SKHVBBD010 ALPS, SKHVBBD010 Datasheet - Page 4

• Manufacturer Part Number: SKHVBBD010
• Description: Tactile & Jog Switches 6.0x6.0x4.3mm 160gf
• Manufacturer: ALPS
• Series: SKHVr

Specifications of SKHVBBD010

• Operating Force: 1.57 N
• Actuator: Top
• Contact Rating: 50 mA at 12 Volts
• Ground Terminal: No
• Contact Form: SPST - NO
• Switch Function: OFF - (ON)
• Termination Style: Through Hole
• Body Size: 6 mm L x 6 mm W x 4.3 mm H
• Color: Dark Gray
• Features: Supplied with radial taping
• Mounting Style: Radial
• Operating Temperature Range: - 20 C to + 70 C
• Travel: 0.25 mm
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: SKHVBB

Power
Push
Slide
Rotary
Encoders
Detector
Dual-in-line
Package Type
Multi Control
Devices
TACT
Custom-
Products
Sharp
Feeling
Soft
Feeling
Snap-in
Type
Surface
Mount Type
Radial
Type
416
TACT Switches
（Except SKHJ, SKHL, SKQC, SKQJ, SKQK, SKEG series）
Available for Surface Mount Type.（Except SKHM, SKHU, SKRM, SKRR Series）
Available for Snap-in Type and Radial Type
Notes
1. The condition mentioned above is the temperature on the mounting surface of a PC board. There are cases where
2. Soldering conditions differ depending on reflow soldering machines. You are requested to verify the soldering
Notes
1. Consult with us for TACT switch washing conditions.
2. Prevent flux penetration from the top side of the TACT switch.
3. Switch terminals and a PC board should not be coated with flux prior to soldering.
4. The second soldering should be done after the switch returns to normal temperature.
5. Use the flux with a specific gravity of at least 0.82.
Preheating temperature
Continuous dipping time
1. Heating method: Double heating method with infrared heater.
2. Temperature measurement: Thermocouple 0.1 to 0.2φ CA （K） or CC （T） at soldering portion （copper foil surface） . A heat resisting tape
3. Temperature profile
Soldering temperature
Soldering Conditions
Number of soldering
the PC board's temperature greatly differs from that of the switch, depending on the PC board's material, size,
thickness, etc. The above-stated conditions shall also apply to switch surface temperatures.
conditions thoroughly beforehand.
（EC-19s-8 by TAMURA Corporation, or their equivalents.）
Condition for Reflow
Conditions for Auto-dip
Preheating time
Flux built-up
Items
Temperature (˚C )
Ambient temperature of the soldered
should be used for fixed measurement.
should not be coated with flax
180
150
Mounting surface
surface of PC board.
2times max.
100℃ max.
260℃ max.
Condition
60s max.
5s max.
120 sec max. （ pre-heating ）
Time inside soldering equipment
3 to 4min.
Available for Manual Soldering Type
Continuous soldering time
Soldering temperature
Manual Soldering
Items
40s max.
260˚C max. 3 sec max.
230˚C
Time
Condition
350℃max.
3s max.