E32-TC200F4 Omron, E32-TC200F4 Datasheet - Page 65
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
E32-TC200F4
Manufacturer Part Number
E32-TC200F4
Description
Fiber Optic Sensors 40MM PROBE
Manufacturer
Omron
Datasheet
1.E39-F13.pdf
(67 pages)
Specifications of E32-TC200F4
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
E32-TC200F4
Manufacturer:
VISHAY
Quantity:
14 230
■ Accessories
Use of E39-R3 Reflector
1. Use detergent, etc., to remove any dust or oil from the
2. The E39-R3 cannot be used in places where it is exposed
E39-F32@ Protective Spiral Tubes
1. Insert a fiber to the Protective
2. Push the fiber into the
3. Secure the Protective
4. Use the attached saddle to
surfaces where tape is applied. Adhesive tape will not be
attached properly if oil or dust remains on the surface.
to oil or chemicals.
Spiral Tube from the head
connector side (screwed) of the
tube.
Protective Spiral Tube. The
tube should be straight so that
the fiber is not twisted when
inserted. Then turn the end cap
of the spiral tube.
Spiral Tube on a suitable
place with the attached
nut.
secure the end cap of the
Protective Spiral Tube. To
secure the Protective Spiral
Tube at a position other than
the end cap, apply tape to the
tube so that the portion
becomes thicker in diameter.
Protective Spiral
Tube
Mounting panel
Protective Spiral
Tube
Protective Spiral
Tube
Tube
Saddle
Hexagon clamping nut
Toothed washer
End cap
Fiber Unit
Fiber Unit
Fiber Unit
E39-F10 Fiber Connector
Mount the Fiber Connector as shown in the following
illustrations.
1. Insert the Fiber Unit into the retention clip.
2. Insert the retention clip into the splice.
• The Fiber Units should be as close as possible when they
• Only 2.2-mm dia. fibers can be connected.
Fiber Unit
are connected.
Sensing distance will be reduced by approximately 25%
when fibers are connected.
Retention unit
Splice
Fiber Unit
Retention
unit
Fiber Unit
Fiber Unit
65