DS90LV011ATMF/NOPB National Semiconductor, DS90LV011ATMF/NOPB Datasheet - Page 3

• Manufacturer Part Number: DS90LV011ATMF/NOPB
• Description: IC DRIVER SGL HS DIFF SOT23-5
• Manufacturer: National Semiconductor
• Type: Driverr

Specifications of DS90LV011ATMF/NOPB

• Number Of Drivers/receivers: 1/0
• Protocol: RS644
• Voltage - Supply: 3 V ~ 3.6 V
• Mounting Type: Surface Mount
• Package / Case: SOT-23-5, SC-74A, SOT-25
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: DS90LV011ATMF; DS90LV011ATMFTR

Note 2: Current into device pins is defined as positive. Current out of device pins is defined as negative. All voltages are referenced to ground except V
Note 3: All typicals are given for: V
Note 4: Output short circuit current (I
Note 5: These parameters are guaranteed by design. The limits are based on statistical analysis of the device performance over PVT (process, voltage,
temperature) ranges.
Note 6: C
Note 7: Generator waveform for all tests unless otherwise specified: f = 1 MHz, Z
Note 8: The DS90LV011A is a current mode device and only function with datasheet specification when a resistive load is applied to the drivers outputs.
Note 9: t
the same channel.
Note 10: t
specification applies to devices at the same V
Note 11: t
operating temperature and voltage ranges, and across process distribution. t
Note 12: f
is guaranteed by design. The limit is based on the statistical analysis of the device over the PVT range by the transitions times (t
Parameter Measurement Information
SKD1
L
SKD3
SKD4
MAX
includes probe and fixture capacitance.
, |t
generator input conditions: t
, Differential Part to Part Skew, is defined as the difference between the minimum and maximum specified differential propagation delays. This
, part to part skew, is the differential channel to channel skew of any event between devices. This specification applies to devices over recommended
PHLD
− t
PLHD
FIGURE 3. Differential Driver Propagation Delay and Transition Time Test Circuit
|, is the magnitude difference in differential propagation delay time between the positive going edge and the negative going edge of
DD
OS
= +3.3V and T
) is specified as magnitude only, minus sign indicates direction only.
r
= t
FIGURE 2. Differential Driver Full Load DC Test Circuit
f
DD
< 1 ns (0% to 100%), 50% duty cycle, 0V to 3V. Output criteria: duty cycle = 45%/55%, V
and within 5°C of each other within the operating temperature range.
FIGURE 1. Differential Driver DC Test Circuit
A
= +25°C.
SKD4
3
O
is defined as |Max − Min| differential propagation delay.
= 50Ω, t
r
≤
1 ns, t
f
≤
20014904
1 ns (10%-90%).
20014903
20014924
TLH
OD
and t
> 250mV. The parameter
THL
).
www.national.com
OD
.