EE-SPX303N Omron Automation, EE-SPX303N Datasheet - Page 5

• Manufacturer Part Number: EE-SPX303N
• Description: Sensor; Indicator; Photomicro; 13 mm; Infrared Light; Dark ON; Modulated Light
• Manufacturer: Omron Automation
• Type: Slot Photoelectricr

Specifications of EE-SPX303N

• Current, Switching: 80 mA
• Ip Rating: IP50
• Mounting Type: Flat Surface
• Output: NPN
• Range, Measurement: 13 mm
• Sensing Mode: Slot
• Technology: Photoelectric
• Termination: 3-Wire Connector
• Voltage, Supply: 24 VDC
• Voltage Range: 12-24 VDC
• Load Rating: 80 mA
• Enclosure Rating: IP50
• Dimensions: 26 mm L x 7.6 mm W x 26 mm H
• Function: Vane
• Indicator: Modulated Light
• Light Source: Infrared Light
• Primary Type: Photoelectric
• Voltage, Switching: 24 VDC

Precautions
Refer the Technical Information Section for general precautions.
J WIRING
A cable with a thickness of AWG24 min. and a length of 5 m max.
must be connected to the output terminals.
To use a cable longer than 5 m, attach a capacitor with a
capacitance of approximately 10 µF to the wires, as shown
below. The distance between the terminal and the capacitor must
be within 5 m:
Do not impose excessive force on the terminals (refer to the
diagram below). Excess force will damage the terminals.
Do not disconnect the EE-1001 or EE-1006 Connector from the
photomicrosensor when power is supplied to the
photomicrosensor, or sensor damage could result.
If the metal mounting base is subjected to inductive electrical
noise, the photomicrosensor can be activated accidentally. If
noise is a problem, take the following precautions:
1. Connect the GND terminal to the mounting base, so there will
5
Cat. No. GC APMS-1
No
OMRON ELECTRONICS LLC
One East Commerce Drive
Schaumburg, IL 60173
be no difference in electric potential between the photomicro-
sensor and mounting base.
OUT
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
12 to 24 VDC
(5 VDC for EE-SPX303-1)
A capacitance of
10
5 m max
µ
F min.
0 V
R
09/02
Terminal
Extension
cable
Specifications subject to change without notice.
2. Connect the negative terminal to the mounting base via a
3. Insert a plastic insulating plate with a thickness of approxi-
Wire, as shown by the following illustration, to connect a small
inductive load (a relay for example) to the photomicrosensor. A
diode must be connected parallel to the relay to absorb the
reverse voltage.
J POWER SUPPLY
When using a standard switching regulator, ground the FG and G
terminal so that the photomicrosensor will be in a stable
operating condition.
0.47-
mately 10 mm between the photomicrosensor and mounting
base.
OUT
OUT
µ
F capacitor.
D
Relay
OMRON CANADA, INC.
Toronto, Ontario M1B 5V8
885 Milner Avenue
Switching
regulator
G
FG
0 V
12 to 24 VDC
(5 VDC for EE-SPX303-1)
Printed in U.S.A.