ZFC101-07B SMC Corporation, ZFC101-07B Datasheet - Page 6

• Manufacturer Part Number: ZFC101-07B
• Description: Filter; 1/4 in.; 20 ANR (Max.); -100 to 0; 12 mm Dia. x 8 mm Dia. x 20 mm L
• Manufacturer: SMC Corporation

Specifications of ZFC101-07B

• Application: Vacuum adsorption transfer, vacuum adsorption retention, vacuum generated air flow
• Diameter, Tube: 1⁄4 in.
• Flow Rate: 20 ANR (Max.)
• Material, Tube: Nylon, Soft Nylon, Polyurethane, Soft Polyurethane
• Pressure, Operating: -100 to 0 kPa
• Size, Element: 12 mm Dia. x 8 mm Dia. x 20 mm L
• Temperature, Operating: 0 to +60 °C

5
These safety instructions are intended to prevent a hazardous situation and/or
equipment damage. These instructions indicate the level of potential hazard by labels of
"Caution", "Warning" or "Danger". To ensure safety, be sure to observe ISO 4414
JIS B 8370
Note 1) ISO 4414 : Pneumatic fluid power -- Recommendations for the application of equipment to transmission and control
Note 2) JIS B 8370 : General Rules for Pneumatic Systems
1.
2.
3.
4.
1. Inspection and maintenance of machinery/equipment should only be performed after confirmation of
2. When equipment is to be removed, confirm the safety process as mentioned above. Cut the supply
3. Before machinery/equipment is restarted, take measures to prevent shooting-out of cylinder piston rod,
1. Conditions and environments beyond the given specifications, or if product is used outdoors.
2. Installation on equipment in conjunction with atomic energy, railway, air navigation, vehicles, medical
3. An application which has the possibility of having negative effects on people, property, or animals,
Do not service machinery/equipment or attempt to remove components until
The compatibility of pneumatic equipment is the responsibility of the person
who designs the pneumatic system or decides its specifications.
Since the products specified here are used in various operating conditions, their compatibility for the
specific pneumatic system must be based on specifications or after analysis and/or tests to meet your
specific requirements.
Only trained personnel should operate pneumatically operated machinery
and equipment.
Compressed air can be dangerous if an operator is unfamiliar with it. Assembly, handling or repair of
pneumatic systems should be performed by trained and experienced operators.
safety is confirmed.
safe locked-out control positions.
pressure for this equipment and exhaust all residual compressed air in the system.
etc. (Bleed air into the system gradually to create back pressure.)
equipment, food and beverages, recreation equipment, emergency stop circuits, press applications, or
safety equipment.
requiring special safety analysis.
Contact SMC if the product is to be used in any of the following conditions:
Safety Instructions
Series
systems
Caution :
Warning :
Danger :
Note 2)
and other safety practices.
ZFC
Operator error could result in injury or equipment damage.
Operator error could result in serious injury or loss of life.
In extreme conditions, there is a possible result of serious injury or loss of life.
Warning
Note 1)
,