31-2367(M23329/4-01,03 AMPHENOL RF, 31-2367(M23329/4-01,03 Datasheet - Page 3

• Manufacturer Part Number: 31-2367(M23329/4-01,03
• Description: connector, rf coaxial, tnc straight plug, crimp-crimp, for rg58, 141 cable, 50 ohm
• Manufacturer: AMPHENOL RF
• Type: Cable Plugr

Specifications of 31-2367(M23329/4-01,03

• Angle: Straight
• Application: True MIL
• Cable Type: RG-58/U,RG/U 141,58,58C
• Contact Plating: Gold
• Finish, Housing: Nickel
• Gender: Male
• Impedance: 50 Ohms
• Material, Contact: Brass
• Material, Dielectric: TFE/Delrin
• Material, Housing: Brass
• Mating Type: Threaded
• Primary Type: TNC
• Temperature, Range: -65 to +165 °C
• Termination: Crimp
• Voltage, Rating: 500 V
• Lead Free Status / Rohs Status: RoHS Compliant part

Assembly Instructions-C37
TNC
QUICKTRIM
Step 1A
Step 1B
Step 2
Step 3
Step 4
Amphenol Corporation Tel: [phone]
®
PLUG
.250
(6.4)
.125(3.2)
Amphenol
Number
31-5061
.250(6.4)
59, 59A, 62, 62A
clamp
nut
RG-/U
Cable
assembly
contact
Hex Size
.068(1.7)
311
Step 1A For all cables listed, except Plenum 62.
Step 1B For Plenum 62 (IBM 4885584). Same as step 1A, and
Step 2
Step 3
Step 4
Center Contact Affixment
Tool 227-944
227-1221-13
Cavity B
Die Set for
plug body TNC
Slide clamp nut over cable. Strip cable to dimension
shown. Cut braid and dielectric square. Do not nick
center conductor.
then slit jacket back .125"(3.2 mm) in four places 90°
apart as shown in illustration.
Slide contact assembly under braid and jacket until braid
butts as shown. Use caution that braid slides over contact
assembly and not inside of it. Be sure center conductor
is visible through side hole of contact. Crimp contact to
conductor using Amphenol CTL-1 crimp tool; or by using
die set 227-1221-13 cavity B in tool frame 227-944.
Insert into connector body.
Tighten clamp nut to a torque of 35 lbf-in.
Tool Number
CTL Series
CTL-1
Amphenol
www.amphenolrf.com
®