ELCSOFT Eaton / Control Automation, ELCSOFT Datasheet - Page 141

• Manufacturer Part Number: ELCSOFT
• Description: ACCESSORY; ELC PROGRAMMING SOFTWARE FOR ELC CONTROLLERS
• Manufacturer: Eaton / Control Automation

7.9 Current Value Setting
This function is only valid in the ladder diagram and the device monitor modes, and use of
this instruction could open a window for modifying current values (as shown below); in this
window, you could modify the current value (16/32 bit) of devices (D, T, C, E, F).
1.
2.
3.
4.
Click “Communication” > “Enter value” to modify current value. (only can be used after
monitoring ladder diagram or device)
You should check suitable format for the device. If device C235 is 32-bit device, you
should check 32 bits and if device D0 is 16 bits, you should check 16 bits. If you check
32 bits for D0, that means D1 will be used for representing 32 bits register and D1 is
upper 16 bits (high word) and D0 is lower 16 bits (low word).
If the current value is the decimal system, the number should be prefixed with a “K”
(e.g. K12345678), or if it is the hexadecimal system, the number should be prefixed
with an “H” (e.g. H5555AAAA), or if it is the floating point, the number should be
prefixed with a “F”(e.g. F3.45), or if it is the binary, the number should be prefixed with
a “B”(e.g. B0100).
In Enter value window, it has a history record for you to enter the repeated instruction
by double click the instruction.
7 Communication
7-21