A22E-MP-01 Sti (Scientific Technologies, Inc.), A22E-MP-01 Datasheet - Page 15

• Manufacturer Part Number: A22E-MP-01
• Description: SWITCH, EMERGENCY STOP, NON-LIGHTED, PUSH-PULL, 40 DIA. HEAD
• Manufacturer: Sti (Scientific Technologies, Inc.)
• Type: Pushbuttonr

Specifications of A22E-MP-01

• Contact Form: 1 NC
• Function: E-Stop
• Mounting Hole Size: 22.3 mm
• Lead Free Status / Rohs Status: RoHS Compliant part

Assembling the Cap
Installing/Replacing the Lamp
Control Box (Enclosure)
• Insert the protrusion of the Tightening Wrench (A22Z-3905) into the Cap slot and then turn to remove the Cap.
• Insert the Lamp Extractor (A22Z-3901) into the lamp, then rotate the Extractor
The Standard-size Legend Plate Frame can
be mounted.
Mount the Frame as shown in the following
diagram. Mount the Switch in the same way
as for an ordinary panel.
while pressing it.
(1) Mounting the Switch
(1) Installing/Replacing from the Panel Surface
Snap-in Legend Plate
Cap slot Protrusion
Emergency Stop Switch
Place the tip of a screwdriver on the surface
where the cable port hole is to be created
with the cover attached and strike the
screwdriver to punch a hole.
Attempts to punch a hole on the other side
of the case will damage the Box.
(2) Creating a Cable Port Hole
• Grip the indicator with your fingers, then rotate the indicator while pressing it
against the Switch.
1. Insert the connector into the cable port hole in the Box and secure
2. Pass the tightening cap through the cable, insert the cable into the
with the Mounting Ring inside the box.
connector, and tighten the tightening cap to secure the cable.
Mounting
RIng
Inside
Box
(2) Installing/Replacing on the Switch
(3) Securing the Connector Cable
Outside
Rubber washer
Connector
7 to 9 dia.
9 to 11 dia.
Cable diameter
Tightening cap
A22Z-3500-1
A22Z-3500-2
Connector
A22E
Cable
15