C35 Bogen Communications, Inc., C35 Datasheet - Page 2

• Manufacturer Part Number: C35
• Description: Amplifier; 35 W; 70 to 16 kHz ( 2 dB) @ 1% (Max.) (Transformer); 85 W; Screw
• Manufacturer: Bogen Communications, Inc.

Specifications of C35

• Controls: MIC1, MIC2⁄AUX (Switch Selected), AUX 2, BASS,TREBLE,TEL,VOX
• Dimensions: 14-1⁄2 in. W x 3-3⁄4 in. H x 11 in. D
• Frequency Response: 70 to 16 kHz (+⁄- 2 dB) @ 1% (Max.) (Transformer)
• Hum And Noise: 55 dB (MIC), 70 dB (AUX, TEL) @ Below Rated Output
• Mounting Type: Rack Mount
• Power Consumption: 85 W
• Power Output: 35 W
• Sensitivity: 600 uV (MIC), 85 mV (AUX), 75 mV (TEL)
• Standards: UL Listed, CSA Certified
• Termination: Screw
• Weight, Shipping: 16 lbs.

Power Output (RMS): C35
Rated
Frequency Response
& Distortion:
Transformer
4-Ohm Direct Output –
Hum and Noise:
MIC
AUX
TEL
Input Sensitivity:
MIC Lo-Z Balanced –
AUX –
TEL –
Outputs:
Specifications
Specifications
120VAC 60Hz 2A
and Engineer
CLASS 2 WIRING ACCEPTABLE
TAPE/BOOSTER
GND
Architect
Technical
220W
COM
CAUTION: REPLACE CIRCUIT BREAKER WITH
†
–
LINK
WMT-1A
SAME TYPE AND RATING
4
† Measured @ 2 dB below FRP
The public address amplifier shall be a Bogen Model
_________, or approved equivalent, with a full
power rating of _______watts. (Specify: C35/35
watts, C60/60 watts or C100/100 watts.) The fre-
quency response (transformer) shall be 70 Hz to 16
kHz ±2 dB
sitivity shall be 600µV for low-impedance balanced
microphones, 85mV for auxiliary inputs, and 75mV
for TEL input. Hum and noise shall be 55 dB below
rated output for the MIC inputs and 70 dB below
rated output for the AUX and TEL inputs.
The amplifier shall provide one dedicated low-imped-
ance balanced microphone input, one dedicated Hi-Z
auxiliary input, and one dedicated telephone line
input, as well as a fourth input that is switch selec-
table to be either a microphone or auxiliary input.
The microphone inputs shall be equipped with filters
to protect against RF interference. Independent vol-
ume controls for each input as well as TREBLE con-
trol (±11 dB @ 10 kHz) and BASS control (±11 dB
@ 100 Hz) shall be incorporated. A precedence cir-
cuit shall mute the AUX 2 input when a customer-
supplied external switch is actuated.
2.5A HOLD
6.25
25V
16
AUX2
OUTPUT RATING 100W
35W
70 - 16 kHz (± 2 dB) @ 1% max.
20 - 20 kHz (± 1 dB) @ 0.5% max.
55 dB below rated output
70 dB below rated output
70 dB below rated output
600µV
85mV
75mV
8, 16 ohms, 25V, 70V transformer-
isolated balanced or unbalanced;
4 ohms direct unbalanced
70V
†
MUTE
, with less than 1% distortion
GND
C60
60W
C100
100W
†
. Input sen-
Output Connections: Screw terminal strip,TAPE/BOOST-
Input Connections:
Controls:
Tone Control:
Power Requirements: 120V AC, 60 Hz
Dimensions:
Shipping Weight:
The amplifier shall include a TEL volume control to
adjust the telephone paging level and a VOX volume
control to adjust the TEL input signal level trigger
point for automatic muting of the AUX inputs.
The amplifier shall provide output impedances of 4-
(direct), 8-, and 16-ohm speaker systems as well as
for 25V and 70V constant voltage systems. Two high-
impedance outputs shall be provided to drive a tape
recorder or booster amplifier and, when used with an
accessory transformer (WMT1A), to feed a 600-ohm
telephone line.
The amplifier shall contain a resettable thermostat in
the power transformer to protect against heat build-
up and short-circuited or overloaded connections.
Provision shall be included to mount the amplifier in
19-inch equipment racks, using an optional rack panel
kit
14-1/2" W x 3-3/4" H x 11" D. Shipping weight shall
be ______lb. (Insert 16 lb. for C35, 18 lb. for C60 or
20 lb. for C100.)
(Model
50 Spring Street, Ramsey, NJ 07446
201-934-8500 FAX: [phone]
Web Site: www.bogen.com
RPK50).
ER jack;WMT1A jack (requires
accessory transformer)
Screw terminals for MIC and TEL,
two AUX Hi-Z jacks
MIC1, MIC2/AUX (switch selected),
AUX 2, BASS,TREBLE,TEL,VOX
Treble, ±11 dB @ 10 kHz;
Bass ±11 dB @ 100 Hz
C35 - 85W; C60 - 148W;
C100 - 220W
14-1/2" W x 3-3/4" H x 11" D
C35 - 16 lb; C60 - 18 lb;
C100 - 20 lb.
Dimensions
AUX2
MIC2
GND
GND
TEL
AUX1
MIC1
BOGEN
GND
VOX
shall
TEL
be