AMG250-N03D SMC Corporation, AMG250-N03D Datasheet - Page 2

no-image

AMG250-N03D

Manufacturer Part Number
AMG250-N03D
Description
Water Separator; 3/8NPT ports; auto drain (N.O.)
Manufacturer
SMC Corporation
Type
Separatorr
Datasheet

Specifications of AMG250-N03D

Brand/series
AMG Series
Flow Rate
750 ANR
Product Type
Separator
Size, Port
3⁄8" NPT
Series
4.4-2
AMG150
AMG250
AMG350
AMG450
Flow Rate
Note) If compressed air is above max. flow, water separator cannot operate well.
AMG
3
1
1
1
/
/
/
/
8
8
4
2
B
B
B
B
AMG850
AMG550
AMG650
Initial condition of element
1
3
1
/
1
/
4
2
B
B
B
qVerify the direction of the compressed air
wMake sure to install this product horizontally. If
qThe element replacement period is when
wWhen it is time to replace the element,
eWhen using a product equipped with a
qPlace this product in a location that is not
wWhen using an auto drain, drain pipes must
eThe bracket that is provided with the product
mentioned in this catalog, and refer
to p.4.0-5 to 4.0-7 for more detailed
precautions of every series.
Be sure to read before handling.
Refer to p.0-26 and 0-27 for Safety
Instructions and common
precautions on the products
flow and the " " mark that indicates the inlet
side of the product before connecting. It
cannot be used with its direction reversed.
it is installed diagonally, sideways, or upside
down, the drainage that was separated by the
element will splash to the secondary side.
the pressure drop has reached 0.1MPa or
2 years have elapsed after it has been
put into use, whichever comes first.
immediately replace it with a new
element. Also replace the O ring and the
gasket.
drain valve, drain guide, or a ball valve,
discharge the drainage before the drain
fluid surface reaches the center of the
sight glass. If it is not discharged
properly, the drainage will flow out to the
secondary side.
likely
internal/external pressure difference exceeds
0.1 MPa, the element could break.
be connected within the following range:
Normally closed (N.C.)
Normally open (N.O.)
AMG850 type (N.O.) ······
When using a normally open (N.O.) auto
drain, because the valve does not close until
the air pressure becomes higher than
0.15MPa, the air could keep discharging from
the drain discharge section of an air
compressor with a small air discharge
volume. Therefore, make sure to use a
normally closed (N.C.) auto drain with a
compressor under 3.7kW.
is for supporting the product itself. Separate
supports must be provided for piping and
other connection devices.
Tube fittings are provided. Therefore, use
a 10mm external tube, and keep the pipe
length within 5m.
Use a tube with a minimum bore of 9mm,
and keep its length within 2.8m.
Caution
Caution
Caution
to
Precautions
Maintenance
Installation
create
Design
pulsations.
······
If
the

Related parts for AMG250-N03D