SS-5F Omron, SS-5F Datasheet

Page 1

... Wide switching capacity range from microvoltage/current loads ( VDC to high-capacity loads 10 250 VAC) Standard operating force, low force or super-low force models available Ordering Information STANDARD TYPE Microvoltage/microcurrent load 0.1 A max. (Bifurcated crossbar contacts) Part Number Contact PCB Terminal Actuator OF Straight Vertical Pin plunger ...

Page 2

... Sealed lead wire terminal models have color-coded leads. * The normally open (SPST-NO) and normally closed (SPST-NC) types are not listed in the Ordering Information tables. Directly consult OMRON. Specifications Microvoltage/microcurrent load type General purpose/resistive load Bifurcated crossbar contacts Contact form NC 125 VAC 0 VDC 0.1 A Inrush current 1 A max ...

Page 3

... SS-10 series must have a power factor of 0.75 min. 3. Lamp load has an inrush current of 10 times the steady-state current. 4. Motor load has an inrush current of 6 times the steady-state current the switch is used circuit and is subjected to inrush current or surge, connect a surge suppressor across the switch. CONTACT RESISTANCE ...

Page 4

... PT max. OT min. MD max. OP Note: 1. Unless otherwise specified, a tolerance of 2. Straight vertical PCB terminal models are shown above. Soldered terminal, Tab (#10) terminal, lead wire terminal, PCB terminal parallel to left and PCB terminal parallel to right are shown in the Terminals section. 4 Electrical service life ...

Page 5

... OT min. MD max. FP max. OP Note: 1. Unless otherwise specified, a tolerance of 2. Straight vertical PCB terminal models are shown above. Soldered terminal, Tab (#10) terminal, lead wire terminal, PCB terminal parallel to left and PCB terminal parallel to right are shown in the Terminals section. Super-low force Low-force models ...

Page 6

... SS-5GL2 (-F) SS-10GL2 Operating characteristics OF max. RF min. OT min. MD max. FP max. OP Note: Unless otherwise specified, a tolerance of 0.4 mm applies to all dimensions. MOUNTING HOLES Standard types Mounting holes below are for reference only. Note: Unless otherwise specified, a tolerance of 6 Super-low force Low-force models model SS-01GL14-F ...

Page 7

... SS TERMINALS General-purpose type PCB terminal, straight vertical (D) Note: Thickness of all the terminals is 0.5 mm. Soldered terminal (blank) APPROVALS UL (File No. E41515)/CSA (File No. LR21642) Type SS-10 series SS-5 series SS-01 series VDE (File No. 5861-3221) Type SS-5 series SEMKO (File Nos. 43-8614026/43-891609) Type SS-10 series SS-5 series Note: The rated values approved by each of the safety standards (e ...