HS5E-B7Y403-G IDEC Corporation, HS5E-B7Y403-G Datasheet - Page 7

• Manufacturer Part Number: HS5E-B7Y403-G
• Description: Switch, Solenoid Lock, with pilot light, 3m cable
• Manufacturer: IDEC Corporation

Specifications of HS5E-B7Y403-G

• Lead Free Status / Rohs Status: RoHS Compliant part

382
Minimum Radius of Hinged Door
•
HS9Z-A52 Actuator
(When the center of the hinged door is on the extension line of the actuator
mounting surface.)
(When the center of the hinged door is on the extension line of the contact
surface of actuator and safety switch.
Changing the Orientation of the Head
•
•
When using the safety switch for a hinged door, refer to the minimum radius
of doors as shown below. For doors with small minimum radius, use adjust-
able actuators (HS9Z-A55).
The head of the HS5E can be mounted in four ways by removing the four
screws from the corners of the HS5E head and reinstalling the head in the
desired orientation. Before wiring the HS5E, replace the head. Before replac-
ing the head, turn the manual unlock part to the UNLOCK position using the
manual unlock key. When reinstalling the head, make sure that no foreign
objects enter the safety switch. Tighten the screws, without leaving space
between the head and body, otherwise the safety switch may malfunction.
Recommended tightening torque: 1.0 ±0.1 N·m
Because deviation or dislocation of a hinged door may occur, make sure of
correct operation of the actual application before installation.
Factory Setting
Door Hinge
Door Hinge
(36.2)
HS5E Series
(41.5)
Head can be rotated.
Door Hinge
Door Hinge
(40.3)
(35)
Safety Switch
Mounting Holes
Safety Switch
Mounting Holes
Operating Instructions
www.idec.com
Actuator Angle Adjustment
•
•
•
•
When using the HS9Z-A55 horizontally-movable actuator
•
•
Mounting Examples
Safety Precautions
•
Using the angle adjustment screw, the actuator angle can be adjusted (refer
to the dimensional drawing).
Adjustable angle: 0 to 20°
The larger the adjusted angle of the actuator, the smaller the applicable
radius of the door opening.
After installing the actuator, open the door. Then adjust the actuator so that
its edge can be inserted properly into the entry slot of the safety switch.
After adjusting the actuator angle, apply loctite to the adjustment screw so
that the screw will not loosen.
When the center of the hinged door is on the extension line of the contact
surface of actuator and safety switch: 50 mm
When the center of the hinged door is on the extension line of the actuator
mounting surface: 70 mm
Before manually unlocking the safety switch, make sure the machine has
come to a complete stop. Manual unlocking during operation may unlock the
switch before the machine stops, and the protection of the safety switch with
solenoid is lost. While the solenoid is energized, do not unlock the actuator
manually (solenoid lock type).
Horizontal Operation
Vertical Operation
Door
Hinge
Door
Hinge
(36.2)
(36.2)
Slide Door Application
HS9Z-A51
Door Stop
Switches
Safety
HS5E
Door
Latch
Keys
Door Interlock Switches
Door Hinge
Door Hinge
(55.5)
(55.5)