0905 TAPESWITCH, 0905 Datasheet - Page 11

• Manufacturer Part Number: 0905
• Description: Switch, Mini Guard, TS-B/32 Inch (808mm)/30
• Manufacturer: TAPESWITCH

Specifications of 0905

• Primary Type: Photoelectric
• Lead Free Status / Rohs Status: RoHS Exempt Product

C6 MULTIFUNCTION INTERFACE CONTROLLER
B Series Interface Controllers
The controller acts as an interface between various low
voltage sensors and the end user device (machine and/or
process control). The C6 Multifunction Interface Controller
is designed to incorporate up to six sensor zones. A
combination of 1 to 3 B Series Light Curtains and/or 1 to 6
sensing products can be configured. It provides the
necessary power to the B Series sensing unit emitter and
receiver and monitors the output signals from the B Series
sensing unit. In addition to the light curtains, the C6 is
specifically engineered for operation with various pressure
sensitive, normally open switches (ribbon switches, sensing
edges/bumpers and switching mats).
The C6 Controller provides a constant monitoring of the
sensing device. In the event of a failure within the sensor or
its cable (open or short circuit) the controller automatically
detects the failure. In addition to the ability to detect a
failure within the sensor or its cabling, the C6 is designed to
detect a failure within the controller itself. The C6 Controller
is a fully self-contained unit within a metal enclosure. It is
intended to be wall mounted and has six knockouts capable
of accepting standard 1/2” or 3/4” conduit. It will accept an
input power source range of 85 to 264 VAC at an input
frequency range of 47 to 63Hz. The unit will also accept a
regulated 24 VDC supply.
The C6 Controller provides the option of setting each zone
for automatic or manual reset. To manually reset the
controller, a key switch is provided on the front panel of the
controller.
The controller provides two redundant safety output relay
contacts (dry contact or voltage free) in which the output
can be configured as normally open or normally closed.
When the output relays are configured as normally open,
the two closed contacts will open when the sensing device
is actuated (i.e., safety mat is stepped on) or should a fault
occur within the safety device or in the event that the power
is removed.
78
TAPESWITCH
CORPORATION
100 Schmitt Boulevard
Farmingdale, NY 11735
Home Page: www.tapeswitch.com
Email: [e-mail]
When the zone(s) is set in Manual Mode the safety outputs
will remain open until the sensing device is clear and a
reset signal is applied. When the zones are set to AUTO,
the safety outputs will reset automatically after the sensing
device is clear.
Each of the six zones is equipped with three indicator lights:
Manual Mode, Output On and Output Off which
aid in providing the status of each zone. The C6 Controller
also has non-safety monitor output relays for each zone.
They are Form C (normally open, common, normally
closed) contact arrangements. The monitor relays are
intended for status purposes only. For detailed Technical
Specifications consult the table in the Interface Controllers
Section of this catalog. (part number 0480)
Tel:[phone]
Fax: [phone]