LQ104S1DG2A Sharp Electronics, LQ104S1DG2A Datasheet

Page 1

... Technical Document LCD Specification LCD Group LQ104S1DG2A LCD Module Product Specification December 2008 SVGA module featuring Strong 2 rating for brightness, contrast, operating range, and shock and vibration tolerance; 350 nits brightness with 500:1 contrast. ...

Page 2

...

Page 3

... LQ104S1DG2A SPEC No. DATE LD-20903A Sep.30.2008 LD-20903B Dec.12.2008 RECORDS OF REVISION PAGE - 1 st Issue 4 5. Absolute Maximum Ratings “Operating temperature (Ambient)” is corrected to “Operating temperature ”. (The error in writing is corrected.) 13 13. Reliability test items High temperature operation test : “Ta = 80℃” is corrected to “Ta (panel surface) = 80℃”. ...

Page 4

... Application This specification applies to color TFT-LCD module, LQ104S1DG2A These specification sheets are the proprietary product of SHARP CORPORATION(”SHARP) and include materials protected under copyright of SHARP. Do not reproduce or cause any third party to reproduce them in any form or by any means, electronic or mechanical, for any purpose, in whole or in part, without the express written permission of SHARP ...

Page 5

Mechanical Specifications Parameter Display size Active area Pixel format Pixel pitch Pixel configuration Display mode Unit outline dimensions *1 Mass Surface treatment *1：excluding backlight cables. Outline dimensions is shown in page 16. 4. Input Terminals 4-1. TFT-LCD panel driving ...

Page 6

Input Terminals Pin No. Symbol 1 GND GND 4 Hsync 5 Vsync 6 GND 7 GND 8 GND GND GND 17 GND ...

Page 7

R/L = High, U/D = Low R/L = High, U/D = High 4-3. Backlight driving CN2 ,CN3 Using connector Corresponding connector : SM02(8.0)B-BHS (JST) Pin no. symbol 1 V Power supply for lamp (High voltage side) HIGH ...

Page 8

Electrical Characteristics 6-1.TFT-LCDpaneldriving Parameter Power Supply voltage Supply Current dissipation Permissive input ripple voltage Input voltage (Low) Input voltage (High) Input current 1 Input current 2 Input current 3 【 NOTE 1】 Vcc-turn-on conditions Ｔ１≦１５ｍｓ ０＜Ｔ２≦１０ｍｓ ０＜Ｔ３≦１００ｍｓ ０＜Ｔ４≦１ｓ Ｔ５＞２００ｍｓ ...

Page 9

Backlight driving The backlight system is an edge-lighting type with double CCFT (Cold Cathode Fluorescent Tube). The characteristics of single lamp are shown in the following table. (It is usually required to measure under the following condition. Parameter Symbol ...

Page 10

Timing Characteristics of input signals Timing diagrams of input signal are shown in Fig.1. 7-1. Timing characteristics Parameter Clock Frequency High time Low time Duty ratio Data Setup time Hold time Horizontal Cycle sync. signal Pulse width Vertical Cycle ...

Page 11

THp Horizontal Sync.signal (Hsync) THc * Only when enable terminal is fixed “LOW” Clock signal (CK) ...

Page 12

Input Signals, Basic Display Colors and Gray Scale of Each Color Colors & Gray scale Gray Scale Black 0 0 − ...

Page 13

Optical Characteristics Parameter Viewing Horizontal θ21, θ22 angle Vertical range Contrast ratio Response Rise time Decay Chromaticity of white Luminance of white White Uniformity Viewing Angle Horizontal θ21, θ22 50% of the range as a Brightness Vertical Definition [Note] ...

Page 14

Definitions of viewing angle range: [Note2] Definition of contrast ratio: The contrast ratio is defined as the following. Contrast Ratio (CR) = [Note3] Definition of response time: The response time is defined as the following figure and shall be ...

Page 15

Precautions a) Be sure to turn off the power supply when inserting or disconnecting the cable sure to design the cabinet so that the module can be installed without any extra stress such as warp or twist. ...

Page 16

Adjusting volume have been set optimally before shipment not change any adjusted value. If adjusted value is changed, the specification may not be satisfied minute particle enters in the module and adheres to an ...

Page 17

... Assembly site code Discernment code Production month (1-9X Japan or China Quantity of module （４Ｓ）LQ104S1DG2A 社内品番： Barcode （１Ｔ）２００８． ９． １ ＬｏｔＮＯ． ： ...

Page 18

The chemical ozone depleting substance is not used. 14-3. Cold cathode fluorescent lamp in LCD panel contains a small amount of mercury, please follow local ordinances or regulations for disposal. (It marks on the back of the module.) ・COLD ...

Page 19

...

Page 20

...

Page 21

... MERCHANTABILITY, FITNESS FOR USE AND FITNESS FOR A PARTICULAR PURPOSE, ARE SPECIFICALLY EXCLUDED event will SHARP be liable, or responsible in any way, for any incidental or consequential economic or property damage. EUROPE Sharp Microelectronics Europe Division of Sharp Electronics (Europe) GmbH Sonninstrasse 3 20097 Hamburg, Germany Phone: 49 (0)180 507 35 07 Fax: (49) 40-2376-2232 www ...