CV500-COV03 Omron, CV500-COV03 Datasheet - Page 80
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
CV500-COV03
Manufacturer Part Number
CV500-COV03
Description
CONNECTOR COVER
Manufacturer
Omron
Datasheet
1.CV500-COV01.pdf
(182 pages)
Specifications of CV500-COV03
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
CV500COV03
- Current page: 80 of 182
- Download datasheet (2Mb)
Inductive Load Surge
Suppressor
Compliance with EC Directives
Requirement
Examples
The following conditions can be used to determine if measures to reduce noise
are necessary. Refer to the EN50081-2 Standard for details.
Connect a surge suppressor or diode in parallel with the load, as shown in the
following diagrams, when switching inductive loads.
CR Method (AC or DC)
The reset time will be increased if the load is a relay, solenoid, or similar device.
Connect the CR between the load connections for 24-V and 48-V power supply
voltages and between the contact connections for 100 to 200-V power supply
voltages.
The capacitor and resistors can be based on the following guidelines.
C:
R:
You will need to adjust the above values depending on the characteristics of the
load, relay, etc., based on the discharge suppression of the capacitor when the
contacts are open and the current control effect of the resistor the next time the
circuit is closed.
The dielectric strength of the capacitor generally needs to be between 200 and
300 V. Use an AC capacitor (without polarity) in an AC circuit.
Diode Method (DC Only)
The energy stored in the coil is impressed on the coil as a current by the action of
the parallel diode and converted to Joule heat by the resistance of the inductive
load. Here, the reset time will be increased even more than for the CR method.
4. The maximum switching capacity of the CV500-PS211 Power Supply Unit is
5. CV-series PCs that meet EC Directives meet the common emission stan-
If the loads of the devices into which the PC is built are switched less than 5
times a minute, then no measures need to be taken.
If the loads of the devices into which the PC is built are switched 5 times or
more a minute, then measures need to be taken.
2 A at 24 VDC when complying with EC Directives (low-voltage directives).
dard (EN50081-2) of the EMC Directives as individual products. When as-
sembled into machinery, however, the noise generated by switching relay
outputs can fail to meet the standard. When noise is excessive, surge killers
must be installed or other measures must be taken outside of the PC. The
measures required to meet the standard will vary with the load being driven,
wiring, the configuration of the machinery, etc.
The following examples show means of reducing noise. These means will
only reduce the amount of noise and will not eliminate noise. They are pro-
vided here as examples only.
Power supply
Inductive load
C
0.5 to 1 F for each amp of contact current
0.5 to 1
R
for each volt of contact voltage.
Section 3-6
67