Z0220516SSGR4259 Zilog, Z0220516SSGR4259 Datasheet - Page 14
![IC MODEM CTRL 86E34 28-SOIC](/photos/6/91/69136/269-28-soic_sml.jpg)
Z0220516SSGR4259
Manufacturer Part Number
Z0220516SSGR4259
Description
IC MODEM CTRL 86E34 28-SOIC
Manufacturer
Zilog
Specifications of Z0220516SSGR4259
Data Format
V.22
Baud Rates
2.4k
Interface
Serial
Voltage - Supply
4.5 V ~ 5.5 V
Mounting Type
Surface Mount
Package / Case
28-SOIC (7.5mm Width)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Z02205
Modem Controller
12
Command
D
&D
Dial
Data Terminal Ready
Options
Function and Description
The D command causes the modem to dial a telephone call according to the digits and
dial modifiers in the dial string following the command. Any commands following the
dial string on a command line are ignored, unless the semicolon dial modifier is the last
character in the dial string. If the modem is off-hook when the Dial command is given,
the modem dials immediately without trying to detect a dial tone. Characters other than
digits and dial modifiers in a dial string are ignored; however, they are counted as
characters in the command line buffer.
If line current sensing is enabled, and line current is detected before the modem is taken
OFF-HOOK when the modem dials, a NO CARRIER result code is displayed and the
modem enters the IDLE state. If the modem needs not dial (that is, ATD with no dial
string), the modem assumes the call was manually established and attempts to make a
connection.
The D command is not valid when the modem is in the On-Line state.
See “Dial Modifiers and “Modem Result Codes for more information.
&D determines how the modem responds to the DTR signal from the terminal. The
country configuration may prevent the modem from detecting terminal DTR. In this
case, the modem assumes DTR is always on. In North America, terminal DTR is
normally detected. If DTR detection has been prevented, the modem will respond with
an ERROR result to this command.
The response to changes in DTR also depends on the &Q and &D commands. This table
defines what happens when DTR goes off for all possible combinations of the &D and
&Q commands. To see what happens when DTR goes on, refer to the &Q command. The
default value is &D0 in North America:
&Q0
&Q1
A
B
C
D
Table 2. AT Command Set (Continued)
&D0
None
The modem hangs up the telephone line and issues an OK result code.
If in the On-Line state, the modem goes into the Command state, and issues
an OK result code.
The modem hangs up the telephone line and issues an OK result code.
Auto-Answer is disabled as long as DTR stays off.
The modem resets.
A
&D1
B
B
&D2
C
C
&D3
D
D
PS001000-MOD0599
ZiLOG