R88A-CAWA005S Omron, R88A-CAWA005S Datasheet - Page 219
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
R88A-CAWA005S
Manufacturer Part Number
R88A-CAWA005S
Description
POWER CABLE 5M
Manufacturer
Omron
Datasheet
1.R88A-CAWA005S.pdf
(249 pages)
Specifications of R88A-CAWA005S
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
R88ACAWA005S
- Current page: 219 of 249
- Download datasheet (5Mb)
Troubleshooting
5-2
Note 1. Refer to 5-3-1 Error Diagnosis Using Alarm Display for appropriate alarm countermeasures.
Note 2. Cancel the alarm using one of the following methods.
Note 3. If an alarm is canceled while RUN is turned ON, the Servo Driver will start as soon as the
■
If an error is detected, an alarm code will be displayed one segment at a time on the Servo Driver’s
front-panel alarm display, as shown in the following example.
Example: Alarm Code A.C2
Servo Driver Alarm Display
• Input a RESET (alarm reset) signal.
• Turn OFF the power supply, then turn it ON again.
• Reset the alarm using the Parameter Unit keys.
If the Servo Driver detects an error, ALM (alarm output) will be output, the power drive
circuit in the Servo Driver will turn OFF, and the alarm will be displayed. If the Servo
Driver detects a warning (e.g., overload warning or regenerative overload warning), a
warning code will be displayed, but operation will continue.)
The following alarms can only be cancelled by turning OFF and ON the power supply: A.04,
A.10, A.bF, A.C2, and A.C3.
Alarms
alarm is cleared, which is dangerous. Be sure to turn OFF the RUN command before can-
celing the alarm.
After
approx. 1 s
After
approx. 1 s
After
approx. 1 s
After
approx. 1 s
...
Chapter 5
5-5