XW2Z-100J-B7 Omron, XW2Z-100J-B7 Datasheet - Page 170
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
XW2Z-100J-B7
Manufacturer Part Number
XW2Z-100J-B7
Description
CABLR DRIVER
Manufacturer
Omron
Datasheet
1.R88A-TK01W.pdf
(252 pages)
Specifications of XW2Z-100J-B7
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
XW2Z100JB7
- Current page: 170 of 252
- Download datasheet (4Mb)
• Be sure that no gaps are created when installing the cover, as gaps can be caused by distortion
■
●
When selecting no-fuse breakers, take into consideration the maximum output current and the inrush
current.
Maximum input current:
The momentary maximum output for a Servo Driver is approximately three times that of the rated
output, and a maximum output of three seconds can be executed. Therefore, select no-fuse breakers
with an operating time of at least five seconds at 300% of the rated maximum output. General-pur-
pose and low-speed no-fuse breakers are generally suitable. The table in 3-2-3 Terminal Block Wir-
ing shows the rated power supply input currents for each Servomotor. Select a no-fuse-breaker with
a rated current greater than the total effective load current (when multiple Servomotors are used).
When making the selection, add in the current consumption of other controllers, and so on.
3-30
System Design and Installation
when tightening screws.
No-fuse Breakers (NFB)
Selecting Components
This section explains the criteria for selecting the connection components required for
improving noise resistance. These criteria include capacity performance, applicable
range, and so on. For more details, contact the manufacturers directly.
A
Case
Control Panel
Case (Inside)
B
Cover
Conductive packing
Oil-proof packing
Oil-proof packing
A-B Cross-section
Conductive packing
Cover
Chapter 3