NT30-CFL01 Omron, NT30-CFL01 Datasheet - Page 283
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
NT30-CFL01
Manufacturer Part Number
NT30-CFL01
Description
REPLACEMENT BACKLIGHT FOR NT30
Manufacturer
Omron
Datasheet
1.NT30C-CFL01.pdf
(466 pages)
Specifications of NT30-CFL01
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
NT30CFL01
- Current page: 283 of 466
- Download datasheet (3Mb)
Using Calculation
Results in Later
Calculations
Recursive Operations
274
Mathematical Function
• Overflow
• Underflow
The mathematical function reads all of the operands before starting to perform
the calculations, so calculation results from one calculation cannot be used in a
later calculation in the same cycle.
The mathematical function’s processing cycle does not match the PC’s cycle
time, so results from two calculations may not be from the same processing
cycle.
It is possible to specify the same numeral memory table or PC word for both the
operands
D02000 = D02000 + 1 increments the contents of D02000 by 1 each time that
the operation is repeated. Since the calculations are always executed while the
PT is operating, D02000 will be incremented each processing cycle while the PT
is operating.
tent is non-zero. (When the denominator is specified from the Support Tool, an
error message will be displayed if you attempt to specify 0.)
An error will occur if the calculation result exceeds the maximum value that can
be stored in the number of words in the result. The maximum value that can be
stored depends upon the data type and number of words set in the memory
table or host. (See the following table for allowed ranges.)
An error will occur if the calculation result is below the minimum value that can
be stored in the number of words in the result. The minimum value that can be
stored depends upon the data type and number of words set in the memory
table or host. (See the following table for allowed ranges.)
* When the host is notified, the leftmost digit is set to F to indicate a negative value.
BCD
Binary
For example, –999 is expressed as F999 and –9,999,999 is expressed as
F999 9999.
Mathematical table 0
Mathematical table 7
Data type
y
and
1
2
1
2
calculation
Number of words
C = A + B
E = C + D
Mathematical table 7 uses the value of C that was
read before mathematical table 0 was executed.
result.
A calculation result cannot be used as a
later calculation’s operand.
–999 to 9,999*
–9,999,999 to 99,999,999*
8000 to 7FFF hexadecimal
8000 0000 to 7FFF FFFF hexadecimal
For
example,
Allowed range
Section
the
operation
2-18