NS7-KBA05 Omron, NS7-KBA05 Datasheet - Page 161
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
NS7-KBA05
Manufacturer Part Number
NS7-KBA05
Description
PROTECTIVE PLASTIC COVER FOR NS7
Manufacturer
Omron
Datasheet
1.NS12-TS01B-V2.pdf
(334 pages)
Specifications of NS7-KBA05
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
NS7KBA05
- Current page: 161 of 334
- Download datasheet (7Mb)
5-2 Connecting to the Host Using Controller Link
5-2-1
What Is a Controller Link Network?
PLC, SYSMAC
CJ Series
This section explains the method for connecting to the host using a Controller Link Interface
Unit.
A Controller Link Network is an FA Network that can send and receive large data packets
flexibly and easily among the OMRON C200HX/HG/HE PLC Programmable Terminal (PTs),
SYSMAC CS-series PLCs, CJ-series PLCs, CQM1H-series PLCs, C200HX/HG/HE PLCs,
CVM1/CV-series PLCs, IBM PC/AT or compatible computers, and NS-series PTs. The Con-
troller Link supports data links that enable data sharing and a message service that enables
sending data and receiving data when required. Data link areas can be freely set to create a
flexible data link system and effectively use data areas.
The network is connected using shielded twisted-pair cable or optical fiber cable. In addition,
the Controller Link Network can transfer large quantities of data at high speed, so that it is
possible to construct a wide-area network easily that supports from low-level systems to high.
For details on data links and message service, refer to the Controller Link Support Board
Operation Manual (W307), Controller Link Support Board for PCI Bus Operation Manual (Cat.
No. W383), and the Controller Link Unit Operation Manual (Cat. No. W309).
Note: An optical fiber cable is not available for NS-series PTs.
To connect the PT to the Controller Link, it is necessary to install a Controller Link Interface
Unit on the PT. A Controller Link Interface Unit can be used only for the NS15, NS12 and
NS10 NS-series PTs. Refer to 3-8 Installing the Controller Link Interface Unit for the proce-
dure for installing and wire the Controller Link Interface Unit.
When communicating by Controller Link, the network number, node number, routing tables,
and data link tables must be set. Use the CX-Designer to set the settings. For details, refer to
System Settings and Project Properties in the CX-Designer’s Online Help.
Required Devices
To construct a Controller Link Network, the devices described in the following table are re-
quired.
CJ1W-CLK21
Controller Link Unit
PLC, SYSMAC
CQM1H Series
CQ1H-CLK21
Controller Link Unit
PLC, SYSMAC
CS Series
CS1W-CLK21
Controller Link Unit
PLC, SYSMAC
C200HX/HG/HE
C200HW-CLK21
Controller Link Unit
PLC, SYSMAC
CVM1/CV Series
5-2 Connecting to the Host Using Controller Link
CVM1-CLK21
Controller
Link Unit
NS Series
NS12-TS@
NT10-TV@
NS-CLK21
Controller Link
Interface Unit
3G8F5-CLK21
Controller Link
Support Board
IBM PC/AT or
compatible
FC98 personal
computer
3G8F6-CLK21
Controller Link
Support Board
Personal computer
5-17
3G8F7-CLK21
Controller Link
Support Board