FNY-NS115 Omron, FNY-NS115 Datasheet - Page 20

• Manufacturer Part Number: FNY-NS115
• Description: W-SERIES & MLII INTERFACE UNIT
• Manufacturer: Omron

Specifications of FNY-NS115

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: FNYNS115

Introduction
1-1
1-1-1
1-1-2
Supports Most
OMRON Inverters and
Servos
Wide Range of
Parameter Editing
Functions
Easy and Dependable
Parameter Editing for
Inverters and Servos
Easily Check Drive
Parameters and Upload/
Download Only Selected
Parameters
Edit Parameters in
Graphic Form
Display Parameters in
Diagrams
Automatically Detect
Drives
2
Introduction
Features
What Is the CX-Drive?
The CX-Drive is a software application that enables 1) setting, downloading,
uploading, and comparing parameters, 2) test runs and tuning, and 3) moni-
toring and data tracing for Inverters and Servos.
Setting parameters,
test runs, and tuning
The CX-Drive can be used with OMRON's 3G3JX, 3G3MX, and 3G3RX,
3G3JV, 3G3MV, and 3G3RV Inverters, as well as OMRON's SMARTSTEP2,
SMARTSTEP, OMNUC G-series, and MECHATROLINK-II compliant (see
note) G-series, OMNUC W-series, and MECHATROLINK-II compliant W-
series Servo Drives.
Inverter and Servo parameters can be edited using parameter numbers or by
category. Parameter editing tables show parameter ID numbers, descriptions,
units, default values, and ranges in the same way as in the Servo manuals.
Parameters can be set using pull-down menus or by typing in settings.
Parameter settings can be easily reviewed because setting status (e.g., mod-
ified, warning, default, or disabled) is shown for each parameter to avoid set-
ting mistakes.
When connected online, you can easily display drive parameters by using a
comparison function. Also, the selected parameters can be downloaded to or
uploaded from the drive as required.
Inverter parameters, such as V/F profiles and jump frequencies, can be dis-
played in graphic charts.
Drive parameters can be displayed in diagrams, such as PID diagrams or
position/speed/torque block diagrams.
The connected drives can be detected automatically and displayed in a list
without setting model numbers or connection types. Just select a drive to add
it to the Workspace.
POWER
ALM
CN3
CN1
CN2
CNB
CNA
Drive
Monitoring/Tracing
Section 1-1