ISP1582BSGA ST-Ericsson Inc, ISP1582BSGA Datasheet - Page 8

• Manufacturer Part Number: ISP1582BSGA
• Description: IC UBS CTRL HI-SPEED 56HVQFN
• Manufacturer: ST-Ericsson Inc

Specifications of ISP1582BSGA

• Applications: USB Host/Peripheral Controller
• Interface: USB
• Voltage - Supply: 3 V ~ 3.6 V
• Package / Case: 56-VQFN Exposed Pad, 56-HVQFN, 56-SQFN, 56-DHVQFN
• Mounting Type: Surface Mount
• For Use With: ISP1582 PCI EVALKIT - PCI BUS EVAL KIT ISP1582
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: ISP1582BS-S; ISP1582BS-S

NXP Semiconductors
AN10039_4
Application note
Fig 4. CATC capture of IN ACK interrupt
Fig 5. CATC capture of OUT ACK and NYET interrupt
2.4 Initializing the Interrupt Enable register
}
The OUT endpoint is programmed to all ACK and NYET interrupts as shown in
Next is the initialization of the Interrupt Enable register (see
respective bit to logic 1 enables the interrupt signal to be generated on the INT pin of the
ISP1582/83. Take into consideration the Interrupt Service Routine (ISR) because an
AND operation must be performed on the bits in the Interrupt register with the Interrupt
Enable register. The Interrupt register reflects the status bit of the respective event, even
if the enable bit is not set in the Interrupt Enable register.
Rev. 04 — 21 December 2006
ISP1582/83 Firmware Programming Guide
Table
4). Setting the
AN10039
© NXP B.V. 2006. All rights reserved.
Fig
5.
7 of 49