W83627HG-AW Nuvoton Technology Corporation of America, W83627HG-AW Datasheet - Page 83

• Manufacturer Part Number: W83627HG-AW
• Description: IC LPC SUPER I/O 128-PQFP
• Manufacturer: Nuvoton Technology Corporation of America

Specifications of W83627HG-AW

• Applications: PC's, PDA's
• Interface: LPC
• Voltage - Supply: 3.3V, 5V
• Package / Case: 128-XFQFN
• Mounting Type: Surface Mount
• Pin Count: 128
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

tion registers. The designer can also set bit 5 of CR26（LOCKREG）to high to protect the configura-
tion registers against accidental accesses.
The configuration registers can be reset to their default or hardware settings only by a cold reset （pin
MR = 1）. A warm reset will not affect the configuration registers.
9.1.1.2
After a power-on reset, the W83627HF/F enters the default operating mode. Before the W83627HF
/Fenters the extended function mode, a specific value must be programmed into the Extended Func-
tion Enable Register（EFER）so that the extended function register can be accessed. The Extended
Function Enable Registers are write-only registers. On a PC/AT system, their port addresses are 2Eh
or 4Eh （as described in previous section）.
9.1.1.3
（EFDRs）
After the extended function mode is entered, the Extended Function Index Register（EFIR）must be
loaded with an index value （02h, 07h-FEh） to access Configuration Register 0（CR0）, Configura-
tion Register 7（CR07）to Configuration Register FE（CRFE）, and so forth through the Extended
Function Data Register（EFDR）. The EFIRs are write-only registers with port address 2Eh or 4Eh
（as described in section 12.2.1）on PC/AT systems; the EFDRs are read/write registers with port
address 2Fh or 4Fh （as described in section 9.2.1） on PC/AT systems.
9.1.2
To program W83627HF/F configuration registers, the following configuration sequence must be
followed：
（1） Enter the extended function mode
（2） Configure the configuration registers
（3） Exit the extended function mode
9.1.2.1
To place the chip into the extended function mode, two successive wrtites of 0x87 must be applied to
Extended Function Enable Registers（EFERs, i.e. 2Eh or 4Eh）.
9.1.2.2
The chip selects the logical device and activates the desired logical devices through Extended Func-
tion Index Register（EFIR） and Extended Function Data Register（EFDR）. EFIR is located at the
same address as EFER, and EFDR is located at address （EFIR+1）.
First, write the Logical Device Number（i.e.,0x07）to the EFIR and then write the number of the de-
sired logical device to the EFDR. If accessing the Chip（Global）Control Registers, this step is not
required.
Secondly, write the address of the desired configuration register within the logical device to the EFIR
and then write （or read） the desired configuration register through EFDR.
Configuration Sequence
Extended Functions Enable Registers （EFERs）
Enter the extended function mode
Configurate the configuration registers
Extended Function Index Registers （EFIRs）, Extended Function Data Registers
- 79 -
W83627HF/ F/ HG/ G
Publication Release Date: June 09, 2006
Revision 2.27