4210-0 Peregrine Semiconductor, 4210-0 Datasheet - Page 2

• Manufacturer Part Number: 4210-0
• Description: KIT EVAL FOR 4210 RF SWITCH
• Manufacturer: Peregrine Semiconductor
• Series: UltraCMOS™r
• Type: Switch, SPDTr

Specifications of 4210-0

• Frequency: 0Hz ~ 3GHz
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: PE4210
• Other names: 4210-00

© Copyright 2000 Peregrine Semiconductor Corp. All rights reserved. Printed in the United States of
America. No part of this publication may be reproduced, photocopied, stored in a retrieval system, or
transmitted by electronic, mechanical or any other means without prior written permission of Peregrine
Semiconductor Corp.
Peregrine Semiconductor Corp., the Peregrine logotype, and UTSi are registered trademarks of Pere-
grine Semiconductor Corp. PE4210, PE4220 and PE4230 are trademarks of Peregrine
Semiconductor Corp.
Peregrine Semiconductor Corp. reserves the right to make improvements to the hardware, firmware or
software described in this manual at any time and without notice. While the accompanying material has
been carefully reviewed to insure the most accurate information possible, the data are not warranted for
absolute accuracy or completeness and are subject to change without notification.
Peregrine Semiconductor Corp. Life Support Policy
Peregrine Semiconductor Corp. products are not intended for use in life-critical situations, or as critical
components in life-support devices or systems.
Life-support devices or systems are defined as devices or systems that are intended for surgical implant
into the body, or that support or sustain life, and whose failure to perform when used in accordance with
the instructions provided by the manufacturer, might result in injury to the user.
This device is intended for use only in a research and development environment. It has not been tested
for compliance with FCC regulations regarding interference with radio frequency energy. It might cause
harmful interference with radio communications. The user assumes responsibility for any interference
caused by this device.
Applications Support
If you have a problem with your evaluation kit or the software, or if you have
applications questions call [phone] and ask for applications support.
You may also contact us by fax or e-mail:
Fax: [phone]
E-Mail: [e-mail]
FCC Labeling Requirement
This device complies with Part 15 of the FCC Rules. O peration is subject to the following two
conditions: (1) this device may cause harmful interference, and (2) this device must accept any
interference received including interference that may cause undesired operation.
Peregrine Semiconductor Corporation®
2
Doc# 79/0036~00A