AT 5 B10 LEM USA Inc, AT 5 B10 Datasheet - Page 2

• Manufacturer Part Number: AT 5 B10
• Description: SENSOR CURRENT 5A MOD
• Manufacturer: LEM USA Inc
• Series: ATr

Specifications of AT 5 B10

• Current - Sensing: 5A
• Accuracy: ±1.5%
• Sensitivity: -
• Current - Supply: -
• Sensor Type: Open Loop
• Voltage - Supply: -
• Output: 0 ~ 10 V
• Frequency: 50/60Hz
• Polarization: Bidirectional
• Operating Temperature: -20°C ~ 60°C
• Package / Case: Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 398-1080

Current Transducer AT-B10
V
V
dCp
dCl
CTI
Notes:
In order to guarantee safe operation of the transducer and to be able to make proper use of all features and functions, please
read these instructions thoroughly!
Safe operation can only be guaranteed if the transducer is used for the purpose it has been designed for and within the limits of
the technical specifications.
Ensure you get up-to-date technical information that can be found in the latest associated datasheet under www.lem.com.
Safe and trouble-free operation of this transducer can only be guaranteed if transport, storage and installation are carried out
correctly and operation and maintenance are carried out with care.
090609/6
b
d
Isolation characteristics
Safety and warning notes
1)
2)
Rated isolation voltage rms
with IEC 61010-1 standards and following conditions:
Rms voltage for AC isolation test
Creepage distance
Clearance distance
Comparative tracking index (Group I)
If insulated cable is used for the primary circuit, the isolation voltage
category can be improved according to the primary cable insulation
category (please refer to the cable manufacturer’s indications)
between primary (completely filling the hole) and secondary.
- Reinforced isolation
- Over voltage category CAT III
- Pollution degree PD2
- Heterogeneous field
Caution! Risk of danger
Ignoring the warnings can lead to serious injury and/or cause damage!
The electric measuring transducer may only be installed and put into operation by qualified personnel that have
rceived an appropriate training.
The corresponding national regulations shall be observed during installation and operation of the transducer and
any electrical conductor.
The transducer shall be used in electric/electronic equipment with respect to applicable standards and safety
rquirements and in accordance with all the related systems and components manufacturers’ operating
instructions.
Caution! Risk of electrical shock
When operating the transducer, certain parts of the module may carry hazardous live voltage (e.g. primary
conductor, power supply).
The user shall ensure to take all measures necessary to protect against electrical shock.
The transducer is a built-in device containing conducting parts that shall not be accessible after installation.
A protective enclosure or additional insulation barrier may be necessary.
The transducer shall not be put into operation if the jaw opening is open (split core version) or the installation is
not completed.
Installation and maintenance shall be done with the main power supply disconnected except if there are no
hazardous live parts in or in close proximity to the system and if the applicable national regulations are fully
observed.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
1)
2)
, 50Hz, 1min.
300
3.5
6
6
600
mm
mm
kV
V
www.lem.com
Page 2/3