CC-720 Panduit Corp, CC-720 Datasheet - Page 2

• Manufacturer Part Number: CC-720
• Manufacturer: Panduit Corp

Specifications of CC-720

• Lead Free Status / Rohs Status: RoHS Not Applicable

9.
10.
11.
12.
13.
14.
15.
16.
CALIBRATION
1.
2.
3.
4.
5.
6.
7.
Copyright © 2002
All Rights Reserved
Apply small amount of grease to bottom side of Spacer (Item #5) and place over the center bolt
hole.
Apply grease to center pivot hole of the Ratchet Plate (Item #6). Assemble the slot end of ratchet
plate onto the L.H. stub bolt. Note: Refer to drawing for proper orientation of ratchet plate,
centering the ratchet plate hole over the spacer and the center bolt hole of the tool.
Caution:
Apply a small amount of grease on the bottom of Spacer (Item # 5) and place it over the ratchet
plate hole, centering it over the bolt.
Place the hole of one end of the Strap (Item #7) on the pawl stud, and center the other hole over
the spacers, ratchet plate hole, and center bolt hole.
Carefully place Guard (Item #3) over the mechanism, centering the large hole over the center bolt,
and the small hole over the pawl stud hole. Insert the ¼-20 button head Cap Screw (Item #2)
through the guard and thread it into the pawl stud until tight. Note: Be sure to keep large hole
aligned with ratchet plate hole while tightening.
Apply a small amount of grease to the diameter of the center Bolt (Item #1) and insert through the
center bolt hole of the guard, strap, ratchet plate, spacers, and tool handles, while pushing out
existing center bolt. Orient the head of the bolt to fit into the anti-rotation hex pocket in the guard.
Put a nut on the center bolt and tighten by hand.
Using the 9/16” wrench, tighten the two nuts, adjusting them to allow free movements of the tool
handles.
Insert any CD-720 die into the tool and secure.
Important: Gage block or die must be installed in tool during calibration.
Cycle tool (3) complete times.
Close handles until jaw plate comes into contact with die block and small amount of back
pressure is felt.
Measure distance between inside of handles. If less than 10 in., turn set screw in RHA clockwise
to tighten. If greater than 13 in., turn set screw in RHA counterclockwise to loosen. Cycle tool
between adjustments.
When finished, repeat Step 4. The dimension from inside of handle to inside of handle should
measure 11.5 in., +/- 1.5 in.
Wipe external surfaces of tool with rust inhibiting oil to remove all excess grease and handprints.
Moving the tool at this time will disrupt the alignment of the parts around the center bolt.
2
PA23999A01
7/2002