223615-1 TE Connectivity, 223615-1 Datasheet - Page 6

• Manufacturer Part Number: 223615-1
• Description: High Speed / Modular Connectors 144P 2MM HDR ASSY
• Manufacturer: TE Connectivity
• Series: 223615r

Specifications of 223615-1

• Number Of Rows: 1
• Number Of Positions / Contacts: 144
• Pitch: 2 mm
• Mounting Style: Through Hole
• Termination Style: Solder Pin
• Housing Material: Liquid Crystal Polymer
• Contact Material: Phosphor Bronze
• Contact Plating: Gold
• Product Type: Connector
• Connector Type: Header
• Pcb Mounting Orientation: Vertical
• Post Type: Press-Fit
• Module Type: Signal
• Voltage Rating (vac): 30
• Number Of Signal Positions: 144
• Sequencing: Yes
• Sequencing Configuration Row A: Mating Post Length 6.5mm, Termination Post Length 4.25mm, Mating Post Length 8mm, Termination Post Length 4.25mm
• Sequencing Configuration Row B: Mating Post Length 6.5mm, Termination Post Length 4.25mm, Mating Post Length 8mm, Termination Post Length 4.25mm
• Sequencing Configuration Row C: Mating Post Length 6.5mm, Termination Post Length 4.25mm, Mating Post Length 8mm, Termination Post Length 4.25mm
• Sequencing Configuration Row D: Mating Post Length 6.5mm, Termination Post Length 4.25mm, Mating Post Length 8mm, Termination Post Length 4.25mm
• Post Plating: Tin Lead over Nickel
• Centerline, Matrix (mm [in]): 2.00 x 2.00 [.079 x .079]
• Contact Type: Pin
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold (30)
• Connector Style: Plug
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Printed Circuit Board
• Application: Free-Board
• Lead Free Status / Rohs Status: Details

4.2.
4.3.
4.4.
Rev C
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets requirements of Figure 1. Failures attributed
to equipment, test setup or operator deficiencies shall not disqualify the product. When product failure
occurs, corrective action shall be taken and samples resubmitted for qualification. Testing to confirm
corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
2.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 3.
Power connectors.
Power connector housings and contacts shall be prepared in accordance with applicable
Instruction Sheets and shall be selected at random from current production. All test groups
shall consist of 5 connectors each of the largest available size. All tests requiring individual
contact measurements shall be conducted on 30 contacts randomly selected over the 5
connectors. Test groups 1 and 2 shall be mounted on printed circuit boards designed to
accommodate vibration and physical shock fixturing providing a series circuit for all contacts
with access to measure termination resistance.
Contact Resistance Measurement Points
Figure 4
108-1441
6 of 8