NOII5SM1300A-QDC ON Semiconductor, NOII5SM1300A-QDC Datasheet - Page 25

• Manufacturer Part Number: NOII5SM1300A-QDC
• Manufacturer: ON Semiconductor

Specifications of NOII5SM1300A-QDC

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Windowing in Y-Direction
Reapply the Y_START pulse after loading a new Y-pointer value
into the YL_REG and YR_REG registers to load a new Y-pointer
into the Y-shift-register.
Every time a Y_START pulse appears, a frame calibration of the
output amplifier occurs.
Figure 28. Windowing in Y-Direction
Rev. 9 | www.onsemi.com | Page 25 of 34
Initialization (Startup Behavior)
To avoid any high current consumption at startup, apply the
SYS_CLOCK signal as soon as possible after or even before
power on of the image sensor. After power on, apply
SYS_RESET for a minimum of five SYS_CLOCK periods to
ensure a proper reset of the on-chip sequencer and timing
circuitry. All internal registers are set to ‘0’ after SYS_RESET is
applied.
Because all the IBIS5-1300 control signals are active high, apply
a low level (before SYS_RESET occurs) to these pins at start up
to avoid latch up.
NOII5SM1300A