NOII5FM1300A-QDC ON Semiconductor, NOII5FM1300A-QDC Datasheet - Page 32

• Manufacturer Part Number: NOII5FM1300A-QDC
• Manufacturer: ON Semiconductor

Specifications of NOII5FM1300A-QDC

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Glass Lid
The IBIS5-1300 image sensor uses a glass lid without any coatings.
As seen in
color devices.
Handling Precautions
For proper handling and storage conditions, refer to the
ON Semiconductor application note AN52561.
Information on Pb-Free Soldering
IBIS5-1300 product was tested successfully for Pb-free
soldering processes, using a reflow temperature profile with
maximum 260°C, minimum 40s at 255°C and minimum 90s at
217°C.
Limited Warranty
ON Semiconductor Image Sensor Business Unit warrants that
the image sensor products to be delivered hereunder if properly
used and serviced, will conform to Seller's published
specifications and will be free from defects in material and
workmanship for two (2) years following the date of shipment. If
a defect were to manifest itself within two (2) years period from
the sale date, ON Semiconductor will either replace the product
or give credit for the product.
Return Material Authorization (RMA)
ON Semiconductor packages all of its image sensor products in
a clean room environment under strict handling procedures and
ships
room-approved shipping containers. Products returned to
ON Semiconductor for failure analysis should be handled under
these same conditions and packed in its original packing
materials, or the customer may be liable for the product.
all
Figure
image
31, the sensor does not use infrared attenuating color filter glass. Provide a filter in the optical path when using
sensor
products
Figure 31. Transmission Characteristics of Glass Lid
in
ESD-safe,
Rev. 9 | www.onsemi.com | Page 32 of 34
clean
Figure 31
RoHS (Pb-free) Compliance
This paragraph reports the use of hazardous chemical
substances as required by the RoHS Directive (excluding
packing material).
Lead, Cadmium, Mercury Hexavalent Chromium, PBB (Polybro-
minated biphenyls), PBDE (Polybrominated diphenyl ethers),
noted as “intentional content: is not available in the IBIS5-1300.
Note ‘Intentional content’ is defined as any material demanding
special attention that is allowed into the product as follows:
■
■
The following case is not treated as ‘intentional content’:
■
Acceptance Criteria Specification
The Product Acceptance Criteria is available on request. This
document contains the criteria to which the IBIS5-1300 is tested
before being shipped.
A chemical composition is added into the inquired product
intentionally to produce and maintain the required performance
and function of the product.
A chemical composition which is used intentionally in the
manufacturing process, that is allowed into the product.
The above material is contained as an impurity into raw
materials or parts of the intended product. The impurity is
defined as a substance that cannot be removed industrially, or
it is produced using a process such as chemical composing or
reaction, and it cannot be removed technically.
shows the transmission characteristics of the glass lid.
NOII5SM1300A