MT48H16M32LFCM-75 IT ES Micron Technology Inc, MT48H16M32LFCM-75 IT ES Datasheet - Page 34
![](/photos/31/34/313421/mfg557-90-vfbga_sml.jpg)
MT48H16M32LFCM-75 IT ES
Manufacturer Part Number
MT48H16M32LFCM-75 IT ES
Description
Manufacturer
Micron Technology Inc
Type
Mobile SDRAMr
Datasheet
1.MT48H16M32LFCM-75_IT_ES.pdf
(86 pages)
Specifications of MT48H16M32LFCM-75 IT ES
Organization
16Mx32
Density
512Mb
Address Bus
15b
Access Time (max)
8/5.4ns
Maximum Clock Rate
133MHz
Operating Supply Voltage (typ)
1.8V
Package Type
VFBGA
Operating Temp Range
-40C to 85C
Operating Supply Voltage (max)
1.95V
Operating Supply Voltage (min)
1.7V
Supply Current
95mA
Pin Count
90
Mounting
Surface Mount
Operating Temperature Classification
Industrial
Lead Free Status / Rohs Status
Compliant
PDF: 09005aef82ea3742
512mb_mobile_sdram_y47m.pdf – Rev. H 12/09 EN
10. May or may not be bank specific; if all banks need to be precharged, each must be in a
11. This command is BURST TERMINATE when CKE is HIGH and DEEP POWER-DOWN when
5. The following states must not be interrupted by any executable command; COMMAND
6. All states and sequences not shown are illegal or reserved.
7. Not bank specific; requires that all banks are idle.
8. Does not affect the state of the bank and acts as a NOP to that bank.
9. READs or WRITEs listed in the Command/Action column include READs or WRITEs with
Read with auto precharge enabled: Starts with registration of a READ command
with auto precharge enabled and ends when
bank will be in the idle state.
Write with auto precharge enabled: Starts with registration of a WRITE command
with auto precharge enabled and ends when
bank will be in the idle state.
INHIBIT or NOP commands must be applied on each positive clock edge during these states.
Refreshing: Starts with registration of an AUTO REFRESH command and ends when
t
Accessing mode register: Starts with registration of a LOAD MODE REGISTER com-
mand and ends when
all banks idle state.
Precharging all: Starts with registration of a PRECHARGE ALL command and ends
when
auto precharge enabled and READs or WRITEs with auto precharge disabled.
valid state for precharging.
CKE is LOW.
RFC is met. After
t
RP is met. After
512Mb: 32 Meg x 16, 16 Meg x 32 Mobile SDRAM
t
RFC is met, the device will be in the all banks idle state.
t
MRD has been met. After
t
RP is met, all banks will be in the idle state.
34
Micron Technology, Inc. reserves the right to change products or specifications without notice.
t
t
RP has been met. After
RP has been met. After
t
MRD is met, the device will be in the
© 2007 Micron Technology, Inc. All rights reserved.
t
t
RP is met, the
Truth Tables
RP is met, the