M25P10-AVMN6TP Micron Technology Inc, M25P10-AVMN6TP Datasheet - Page 10
![no-image](/images/manufacturer_photos/0/4/441/micron_technology_inc_sml.jpg)
M25P10-AVMN6TP
Manufacturer Part Number
M25P10-AVMN6TP
Description
Manufacturer
Micron Technology Inc
Datasheet
1.M25P10-AVMN6TP.pdf
(38 pages)
Specifications of M25P10-AVMN6TP
Lead Free Status / Rohs Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
M25P10-AVMN6TP
Manufacturer:
MICRON
Quantity:
11 200
Company:
Part Number:
M25P10-AVMN6TP
Manufacturer:
Numonyx
Quantity:
47 500
Company:
Part Number:
M25P10-AVMN6TP
Manufacturer:
ST
Quantity:
144
Company:
Part Number:
M25P10-AVMN6TP
Manufacturer:
MICRON85
Quantity:
4 940
Part Number:
M25P10-AVMN6TP
Manufacturer:
ST
Quantity:
20 000
M25P10-A
Hold Condition
The Hold (HOLD) signal is used to pause any se-
rial communications with the device without reset-
ting the clocking sequence. However, taking this
signal Low does not terminate any Write Status
Register, Program or Erase cycle that is currently
in progress.
To enter the Hold condition, the device must be
selected, with Chip Select (S) Low.
The Hold condition starts on the falling edge of the
Hold (HOLD) signal, provided that this coincides
with Serial Clock (C) being Low (as shown in Fig-
ure 6).
The Hold condition ends on the rising edge of the
Hold (HOLD) signal, provided that this coincides
with Serial Clock (C) being Low.
If the falling edge does not coincide with Serial
Clock (C) being Low, the Hold condition starts af-
ter Serial Clock (C) next goes Low. Similarly, if the
Figure 6. Hold Condition Activation
10/38
HOLD
C
(standard use)
Condition
Hold
rising edge does not coincide with Serial Clock (C)
being Low, the Hold condition ends after Serial
Clock (C) next goes Low. (This is shown in Figure
6).
During the Hold condition, the Serial Data Output
(Q) is high impedance, and Serial Data Input (D)
and Serial Clock (C) are Don’t Care.
Normally, the device is kept selected, with Chip
Select (S) driven Low, for the whole duration of the
Hold condition. This is to ensure that the state of
the internal logic remains unchanged from the mo-
ment of entering the Hold condition.
If Chip Select (S) goes High while the device is in
the Hold condition, this has the effect of resetting
the internal logic of the device. To restart commu-
nication with the device, it is necessary to drive
Hold (HOLD) High, and then to drive Chip Select
(S) Low. This prevents the device from going back
to the Hold condition.
(non-standard use)
Condition
Hold
AI02029D