L-1CP-1YR-USCAN CADSOFT, L-1CP-1YR-USCAN Datasheet - Page 3
![14T0306](/photos/24/19/241907/4623456_sml.jpg)
L-1CP-1YR-USCAN
Manufacturer Part Number
L-1CP-1YR-USCAN
Description
14T0306
Manufacturer
CADSOFT
Datasheet
1.L-10CP-USCAN.pdf
(4 pages)
Specifications of L-1CP-1YR-USCAN
Software Application
PCB Design, Layout Editor
Software Edition
Professional
No. Of User Licenses
1
Supported Hosts
Windows 2000, XP, Vista, Linux, Mac OS X V10.4
Rohs Compliant
NA
Autorouter Module
Standard Edition
The following restrictions apply to the Standard Edition:
Light Edition
The following restrictions apply to the EAGLE Light Edition:
Larger Layout and Schematic files can be printed with the smaller editions.
The CAM processor can generate manufacturing data as well.
automatic generation of supply signals
Electrical Rule Check (error check in the Schematic and consistency
fully integrated into basic program
uses the layout's Design Rules
change between manual and automatic routing at any time
basic engine for the Followme router, a tool that supports
ripup&retry algorithm
userdefinable strategy by cost factors
routing grid down to 0.02 mm (about 0.8 mil)
no placement restrictions
up to 16 signal layers (with user definable preferred directions)
up to 14 supply layers
full support of Blind and Buried vias
takes into consideration various net classes
The layout area is restricted to a maximum of 160 x 100 mm
A maximum number of 4 signal layers are allowed (top, bottom,
The Schematic can have a maximum of 99 sheets.
The board area is restricted to 100 x 80 mm (about 3.9 x 3.2 inches).
Only two signal layers can be used (no inner layers).
A schematic can consist of only one single sheet.
check between Schematic and Layout)
you in manual routing; the trace of a selected signal will be
calculated automatically
(about 6.3 x 3.9 inches). Outside this area it is not possible to place
packages and draw signals.
and 2 inner layer).
Outside this area it is not possible to place packages and draw signals.