SI2434-D-FS Silicon Laboratories Inc, SI2434-D-FS Datasheet - Page 81
![no-image](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_sml.jpg)
SI2434-D-FS
Manufacturer Part Number
SI2434-D-FS
Description
IC ISOMODEM SYSTEM-SIDE 16SOIC
Manufacturer
Silicon Laboratories Inc
Specifications of SI2434-D-FS
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
- Current page: 81 of 304
- Download datasheet (5Mb)
Notes:
Command
1. When in autobaud mode, \B0, \B1, and \P1 is not detected automatically. The combination of \B2 and \P3 is detected.
2. After changing the baud rate, the result code OK is sent at the old DTE rate. Subsequent commands must be sent at
3. The autobaud feature does not detect this rate.
4. Default is \T16 if autobaud is selected by reset-strap option; otherwise default is \T9 (19.2 kbps).
%V2
\Bn
\B0
\B1
\B2
\B3
\B5
\B6
\Nn
\N0
\$
This is compatible with seven data bits, no parity, two stop bits. Seven data bits, no parity, one stop bit may be forced by
sending AT\T17\B1.
the new rate. If the ISOmodem is configured in autobaud mode, AT commands \T0 through \T15 lock the new baud rate
and disable autobaud. To eliminate any possibility of a race condition between the receipt of the result code and the
changing of the UART speed, CTS is de-asserted while the result code is being sent until after the rate has been
successfully changed. The host should send the \T command and wait for the OK response. After OK has been
received, the host may send data at the new rate as soon as CTS is asserted. The \T command should be the last
command sent in a multi-command line and may not be used on the same command line as :U or :R commands. If it is
not, the OK from the \T command is sent at the old DTE rate, and other result codes are sent at the new DTE rate.
7P1—Seven data bits, parity optioned by \P, one stop bit, one start bit, ten bits total
Display AT\ command settings (see text for details).
Character length is automatically set in autobaud mode.
Reserved
7N1—Seven data bits, no parity, one stop bit, one start bit, nine bits total (\N0 only)
8N1—Eight data bits, no parity, one stop bit, one start bit, 10 bits total (default)
8P1—Eight data bits, parity optioned by \P, one stop bit, one start bit, 11 bits total (\N0 only) This
mode is not allowed with a parallel or SPI interface.
8X1—Eight data bits, one escape bit, one stop bit, one start bit, 11 bits total (enables ninth-bit
escape mode) This mode is not allowed with a parallel or SPI interface.
Asynchronous protocol.
Wire mode (no error correction, no compression).
Automatic Line Status Detection - Adaptive Method.
Description: Before going off-hook with the ATD, ATO, or ATA commands, the ISOmodem compares
the line voltage (via LVCS) to the NLIU (U85) register:
Loop Voltage
0 LVCS (0.0625 x NLIU)
(0.0625 x NLIU) < LVCS (0.85 x NLIU)
(0.85 x NLIU) < LCVS
The NLIU register is updated every 1 ms with the minimum non-zero value of LVCS in the last
30 ms. This allows the ISOmodem to eliminate errors due to 50/60 Hz interference and also adapt
to relatively slow changes in the on-hook dc reference value on the telephone line. This algorithm
does not allow any non-zero values for NLIU below 0x0007. The host may also initialize NLIU prior
to issuing the %V2 command. Once the call has begun, the off-hook intrusion algorithm (described
in "6.6.2. Off-Hook Condition" on page 162) operates normally. In addition, the ISOmodem reports
NO LINE if the telephone line is completely disconnected. If the HOI (U77, bit 11) bit is set, LINE IN
USE is reported upon intrusion.
Table 41. Extended AT% Command Set (Continued)
Table 42. Extended AT\ Command Set
Rev. 1.3
Action
Report NO LINE and remain on-hook.
Report LINE IN USE and remain on-hook.
Go off-hook and establish a modem connection.
Action
AN93
81
Related parts for SI2434-D-FS
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![SI2434-C-FSR](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
SOIC 16/C/33.6 KBPS ISOMODEM 16-PIN SYSTEM-SIDE - LEAD-FREE
Manufacturer:
Silicon Laboratories Inc
![SI2434-C-GTR](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
TSSOP 24/I/33.6 KBPS ISOMODEM SYSTEM-SIDE
Manufacturer:
Silicon Laboratories Inc
![SI2434-D-FSR](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
SOIC 16/C/33.6 KBPS ISOMODEM 16-PIN SYSTEM-SIDE - LEAD-FREE
Manufacturer:
Silicon Laboratories Inc
![SI2434-C-FT](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
IC ISOMODEM SYSTEM-SIDE 24TSSOP
Manufacturer:
Silicon Laboratories Inc
Datasheet:
![SI2434-C-FS](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
Modem Chip Chipset 33.6Kbps 16-Pin SOIC
Manufacturer:
Silicon Laboratories Inc
Datasheet:
![SI2434-C-FTR](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
Modem Chip Chipset 33.6Kbps 24-Pin TSSOP T/R
Manufacturer:
Silicon Laboratories Inc
Datasheet:
![SI2434-C-GT](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
Manufacturer:
Silicon Laboratories Inc
Datasheet:
![SI2434-FT](/photos/16/3/160307/soic-16_tmb.jpg)
Part Number:
Description:
Telecom ICs CONTACT SILICON LABS FOR AVAILABILITY
Manufacturer:
Silicon Laboratories Inc
Datasheet:
![SI2434-C-FT-R](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
IC ISOMODEM SYSTEM-SIDE 24TSSOP
Manufacturer:
Silicon Laboratories Inc
![SI2434-D-FT](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
IC ISOMODEM SYSTEM-SIDE 24TSSOP
Manufacturer:
Silicon Laboratories Inc
Datasheet:
![500SAAB8M00000ACF](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
SMD/C/SINGLE-ENDED OUTPUT SILICON OSCILLATOR
Manufacturer:
Silicon Laboratories Inc
![SI3210MFT](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
Manufacturer:
Silicon Laboratories Inc
Datasheet:
![4010-DAAKF_868](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_tmb.jpg)
Part Number:
Description:
N/A N/A/SI4010 AES KEYFOB DEMO WITH LCD RX
Manufacturer:
Silicon Laboratories Inc
Datasheet: