SI2457-D-FS Silicon Laboratories Inc, SI2457-D-FS Datasheet - Page 171
SI2457-D-FS
Manufacturer Part Number
SI2457-D-FS
Description
IC ISOMODEM SYSTEM-SIDE 16SOIC
Manufacturer
Silicon Laboratories Inc
Specifications of SI2457-D-FS
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
- Current page: 171 of 304
- Download datasheet (5Mb)
6.11. Telephone Voting Mode
The telephone voting mode (TVM) of operation monitors the line to detect polarity reversals after dialing. It waits for
a busy tone to be detected and reports POLARITY REVERSAL or NO POLARITY REVERSAL followed by OK.
To enable TVM, use the G character in the dial string (eg. ATDTG1). The G character must be used for each TVM
call. The S7 timer operates during TVM and indicates NO CARRIER if a timeout occurs before the busy tone is
detected. Polarity reversal monitoring begins after the last digit is dialed and ends at the detection of the busy tone.
Any loss of line-side power (drop out) is considered a polarity reversal if loop current is restored within U51
milliseconds.
6.12. V.92 Quick Connect
The Si2493 supports ITU-T V.92 shortened Phase 1 and Phase 2 to decrease the time required to connect to a
server modem using the V.90 modulation. After the first call, the Si2493 will retain line parameters that allow it to
use shortened Phase 1 and 2 to reduce the total negotiation time. If line conditions change or the remote server
does not support the shortening of these phases, the modem will automatically connect with the normal Phase 1
and Phase 2 negotiation unless specifically commanded not to. Two AT commands control this feature: AT+PQC
and AT+PSS.
The AT+PQC command controls the enabling and disabling of shortened Phase 1 and Phase 2 individually
according to Table 108. It is recommended that both shortened phases be used to realize the maximum reduction
in connect time. The possible settings of the AT+PSS command are shown in Table 109. The AT+PSS command
may be used to force quick connect by setting AT+PSS = 1; however, this is not recommended because calling a
server that does not support this feature will result in a failed connection.
<Value>
10
12
13
11
0
1
2
3
4
5
6
7
8
9
Table 107. Possible +PMHT Settings
Deny V.92 Modem-on-Hold Request
Grant MOH with 10 second timeout
Grant MOH with 20 second timeout
Grant MOH with 30 second timeout
Grant MOH with 40 second timeout
Grant MOH with 1 minute timeout
Grant MOH with 2 minute timeout
Grant MOH with 3 minute timeout
Grant MOH with 4 minute timeout
Grant MOH with 6 minute timeout
Grant MOH with 8 minute timeout
Grant MOH with 12 minute timeout
Grant MOH with 16 minute timeout
Grant MOH with indefinite timeout
Rev. 1.3
Description
AN93
171
Related parts for SI2457-D-FS
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
TSSOP 24/C/56 KBPS, V.90 ISOMODEM SYSTEM-SIDE
Manufacturer:
Silicon Laboratories Inc
Part Number:
Description:
TSSOP 24/I/56 KBPS, V.90 ISOMODEM SYSTEM-SIDE
Manufacturer:
Silicon Laboratories Inc
Part Number:
Description:
IC ISOMODEM SYSTEM-SIDE 16SOIC
Manufacturer:
Silicon Laboratories Inc
Datasheet:
Part Number:
Description:
IC ISOMODEM SYSTEM-SIDE 24TSSOP
Manufacturer:
Silicon Laboratories Inc
Datasheet:
Part Number:
Description:
IC ISOMODEM SYSTEM-SIDE 24TSSOP
Manufacturer:
Silicon Laboratories Inc
Datasheet:
Part Number:
Description:
Manufacturer:
Silicon Laboratories Inc
Datasheet:
Part Number:
Description:
IC ISOMODEM SYSTEM-SIDE 24TSSOP
Manufacturer:
Silicon Laboratories Inc
Datasheet:
Part Number:
Description:
SMD/C/SINGLE-ENDED OUTPUT SILICON OSCILLATOR
Manufacturer:
Silicon Laboratories Inc
Part Number:
Description:
Manufacturer:
Silicon Laboratories Inc
Datasheet:
Part Number:
Description:
N/A N/A/SI4010 AES KEYFOB DEMO WITH LCD RX
Manufacturer:
Silicon Laboratories Inc
Datasheet:
Part Number:
Description:
N/A N/A/SI4010 SIMPLIFIED KEY FOB DEMO WITH LED RX
Manufacturer:
Silicon Laboratories Inc
Datasheet:
Part Number:
Description:
N/A/-40 TO 85 OC/EZLINK MODULE; F930/4432 HIGH BAND (REV E/B1)
Manufacturer:
Silicon Laboratories Inc