W29EE512T-70 Winbond Electronics, W29EE512T-70 Datasheet - Page 4

• Manufacturer Part Number: W29EE512T-70
• Manufacturer: Winbond Electronics

Specifications of W29EE512T-70

• Density: 512Kb
• Access Time (max): 70ns
• Interface Type: Parallel
• Boot Type: Not Required
• Address Bus: 16b
• Operating Supply Voltage (typ): 5V
• Operating Temp Range: 0C to 70C
• Package Type: TSOP-I
• Program/erase Volt (typ): 5V
• Sync/async: Asynchronous
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 4.5V
• Operating Supply Voltage (max): 5.5V
• Word Size: 8b
• Number Of Words: 64K
• Supply Current: 50mA
• Mounting: Surface Mount
• Pin Count: 32
• Lead Free Status / Rohs Status: Not Compliant

W29EE512
Hardware Data Protection
The integrity of the data stored in the W29EE512 is also hardware protected in the following ways:
(1) Noise/Glitch Protection: A #WE pulse of less than 15 nS in duration will not initiate a write cycle.
(2) V
Power Up/Down Detection: The programming and read operation are inhibited when V
is
CC
CC
less than 2.8V.
(3) Write Inhibit Mode: Forcing #OE low, #CE high, or #WE high will inhibit the write operation. This
prevents inadvertent writes during power-up or power-down periods.
Data Polling (DQ
)-Write Status Detection
7
The W29EE512 includes a data polling feature to indicate the end of a programming cycle. When the
W29EE512 is in the internal programming cycle, any attempt to read DQ
of the last byte loaded during
7
the page/byte-load cycle will receive the complement of the true data. Once the programming cycle is
completed. DQ
will show the true data.
7
Toggle Bit (DQ
)-Write Status Detection
6
In addition to data polling, the W29EE512 provides another method for determining the end of a
program cycle. During the internal programming cycle, any consecutive attempts to read DQ
will
6
produce alternating 0's and 1's. When the programming cycle is completed, this toggling between 0's
and 1's will stop. The device is then ready for the next operation.
5-Volt-only Software Chip Erase
The chip-erase mode can be initiated by a six-byte command sequence. After the command loading
cycles, the device enters the internal chip erase mode, which is automatically timed and will be
completed in 50 mS. The host system is not required to provide any control or timing during this
operation.
Product Identification
The product ID operation outputs the manufacturer code and device code. Programming equipment
automatically matches the device with its proper erase and programming algorithms.
The manufacturer and device codes can be accessed by software or hardware operation. In the
software access mode, a six-byte command sequence can be used to access the product ID. A read
from address 0000H outputs the manufacturer code (DAh). A read from address 0001H outputs the
device code (C8h). The product ID operation can be terminated by a three-byte command sequence.
In the hardware access mode, access to the product ID is activated by forcing #CE and #OE low,
#WE high, and raising A9 to 12 volts.
- 4 -