M27C1001-90C6 STMicroelectronics, M27C1001-90C6 Datasheet - Page 10

• Manufacturer Part Number: M27C1001-90C6
• Manufacturer: STMicroelectronics

Specifications of M27C1001-90C6

• Density: 1Mb
• Organization: 128Kx8
• Interface Type: Parallel
• Bus Type: Parallel
• In System Programmable: External
• Access Time (max): 90ns
• Package Type: PLCC
• Reprogramming Technique: OTP
• Operating Supply Voltage (typ): 5V
• Operating Supply Voltage (min): 4.5V
• Operating Supply Voltage (max): 5.5V
• Supply Current: 50mA
• Pin Count: 32
• Mounting: Surface Mount
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Lead Free Status / Rohs Status: Not Compliant

Device description
2.7
2.8
2.9
10/24
Figure 5.
Program Inhibit
Programming of multiple M27C1001s in parallel with different data is also easily
accomplished. Except for E, all like inputs including G of the parallel M27C1001 may be
common. A TTL low level pulse applied to a M27C1001's P input, with E low and V
12.75V, will program that M27C1001. A high level E input inhibits the other M27C1001s from
being programmed.
Program Verify
A verify (read) should be performed on the programmed bits to determine that they were
correctly programmed. The verify is accomplished with E and G at V
12.75V and V
Electronic Signature
The Electronic Signature (ES) mode enables the reading out of a binary code from an
EPROM that will identify its manufacturer and type. This mode is intended for use by
programming equipment to automatically match the device to be programmed with its
corresponding programming algorithm. The ES mode is functional in the 25°C ± 5°C
ambient temperature range that is required when programming the M27C1001. To activate
the ES mode, the programming equipment must force 11.5V to 12.5V on address line A9 of
the M27C1001, with V
device outputs by toggling address line A0 from V
held at V
IL
during Electronic Signature mode.
Programming Flowchart
CC
at 6.25V.
PP
= V
YES
NO
CC
FAIL
= 25
++n
= 5V. Two identifier bytes may then be sequenced from the
V CC = 6.25V, V PP = 12.75V
CHECK ALL BYTES
NO
2nd: V CC = 4.2V
P = 100 s Pulse
1st: V CC = 6V
VERIFY
n = 0
Addr
Last
YES
YES
NO
IL
to V
++ Addr
IH
. All other address lines must be
AI00715C
IL
, P at V
IH
, V
M27C1001
PP
PP
at
at