PC82573E Intel, PC82573E Datasheet - Page 14

• Manufacturer Part Number: PC82573E
• Description: Ethernet CTLR Single Chip 10Mbps/100Mbps/1000Mbps 1.2V/2.5V/3.3V 196-Pin TFBGA
• Manufacturer: Intel

Specifications of PC82573E

• Package: 196TFBGA
• Standard Supported: IEEE 1149.1|IEEE 802.3|IEEE 802.3ab|IEEE 802.3q1|IEEE 802.3x
• Communication Mode: Full Duplex|Half Duplex
• Data Rate: 10|100|1000 Mbps
• Host Interface: PCI
• Operating Supply Voltage: 1.2|2.5|3.3 V
• Dma Support: Yes
• Maximum Power Dissipation: 1.35 W

2.6
14
PHY Analog and Crystal Signals
MDI0n
MDI0p
MDI1n
MDI1p
MDI2n
MDI2p
MDI3n
MDI3p
PHY_REF
XTAL1
XTAL2
Signal
A
A
A
A
A
I
O
Type
Media Dependent Interface [0]
1000BASE-T:
In MDI configuration, MDIp0/MDIn0 corresponds to BI_DA+/-, and in MDI-X
configuration, MDIp0/MDIn0 corresponds to BI_DB+/-.
100BASE-TX:
In MDI configuration, MDIp0/MDIn0 is used for the transmit pair, and in MDI-X
configuration, MDIp0/MDIn0 is used for the receive pair.
10BASE-T:
In MDI configuration, MDIp0/MDIn0 is used for the transmit pair, and in MDI-X
configuration, MDIp0/MDIn0 is used for the receive pair.
Media Dependent Interface [1]
1000BASE-T:
In MDI configuration, MDIp1/MDIn1 corresponds to BI_DB+/-, and in MDI-X
configuration, MDIp1/MDIn1 corresponds to BI_DA+/-.
100BASE-TX:
In MDI configuration, MDIp1/MDIn1 is used for the receive pair, and in MDI-X
configuration, MDIp1/MDIn1 is used for the transmit pair.
10BASE-T:
In MDI configuration, MDIp1/MDIn1 is used for the receive pair, and in MDI-X
configuration, MDIp1/MDIn1 is used for the transmit pair.
Media Dependent Interface [2]
1000BASE-T:
In MDI configuration, MDIp2/MDIn2 corresponds to BI_DC+/-, and in MDI-X
configuration, MDIp2/MDIn2 corresponds to BI_DD+/-.
100BASE-TX:
Unused.
10BASE-T:
Unused.
Media Dependent Interface [3]
1000BASE-T:
In MDI configuration, MDIp3/MDIn3 corresponds to BI_DD+/-, and in MDI-X
configuration, MDIp3/MDIn3 corresponds to BI_DC+/-.
100BASE-TX:
Unused.
10BASE-T:
Unused.
Reference Input
This signal is used as the analog reference input for the PHY. It should be
connected to a pull-down, 4.99 K Ω, 1% resistor.
Crystal One
The Crystal One pin is a 25 MHz input signal. It should be connected to a parallel
resonant crystal with a frequency tolerance of 30 ppm. The other end of the crystal
should be connected to XTAL2.
Crystal Two
Crystal Two is the output of an internal oscillator circuit used to drive a crystal into
oscillation.
Name and Function
82573—Datasheet