RC1/2335%R Stackpole Electronics Inc, RC1/2335%R Datasheet - Page 3

• Manufacturer Part Number: RC1/2335%R
• Manufacturer: Stackpole Electronics Inc
• Type: Carbon Compositionr

Specifications of RC1/2335%R

• Power Rating(s): 1/2W
• Resistance: 33ohm
• Tolerance (+ Or -): 5%
• Termination Style: Axial
• Operating Temp Range: -55C to 125C
• Case Style: Molded
• Failure Rate: Not Required
• Lead Spacing (nom): Not Requiredmm
• Product Length (mm): 9.5mm
• Product Depth (mm): Not Requiredmm
• Product Height (mm): Not Requiredmm
• Construction: Cylindrical
• Lead Free Status / Rohs Status: Compliant

RC Series
Carbon Composition Resistor
Technical Guide:
1. Storage Conditions:
2. Application precautions:
3. Washing:
4. Soldering Recommendations:
Other:
1. Evaluate and confirm the compatibility of your assembly process with this product.
2. Refer to the catalog, the product news, and the specifications for details on the RC series resistors.
3. If you have any questions, please contact our sales staff.
Rev Date: 09/20/2010
This specification may be changed at any time without prior notice
Please confirm technical specifications before you order and/or use.
Temperature:
Humidity:
Term:
Environment:
Lead forming:
Solding:
Carbon composition resistors are highly hygroscopic and changes in resistance value can occur if too much
moisture is absorbed. For this reason it is recommended not to use water or water-soluble solvents to clean these
components. Alcohol or hydrocarbon solvents are recommended for rinsing.
Note: The conditions shown below are for reference. Please perform a mounting evaluation to assure compatibility.
a. Flow soldering (recommended profile for Sn and Sn/Pb solders)
b. Soldering iron (recommended for Sn and Sn/Pb solders)
Temperature of soldering tip:
Temperature of soldering tip:
5 to 35ºC (40 to 95ºF)
25 – 60% relative humidity
2 years in factory poly-bag package (with desiccant)
clean, dry environment, free of corrosive gases
forming is recommended at least 2mm of farther from the base of the lead
soldering is recommended at least 4mm or farther from the base of the lead
300ºC, duration: 10 sec. max.
350ºC, duration: 3 sec. max.
3
Stackpole Electronics, Inc.
Resistive Product Solutions
[e-mail]
www.seielect.com