ATA5428-PLQW 80 Atmel, ATA5428-PLQW 80 Datasheet - Page 13

• Manufacturer Part Number: ATA5428-PLQW 80
• Manufacturer: Atmel

Specifications of ATA5428-PLQW 80

• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Product Depth (mm): 7mm
• Product Height (mm): 0.9mm
• Product Length (mm): 7mm
• Lead Free Status / Rohs Status: Compliant

4841D–WIRE–10/07
Figure 3-2.
As can be seen in
perature has an influence of about +1.5/–0.7 dB, and a frequency offset of ±65 kHz also
influences by about ±1 dB. All these influences, combined with the sensitivity of a typical IC, are
then within a range of –103.7 dBm and –107.3 dBm over temperature, supply voltage and fre-
quency offset which is –105.5 dBm ±1.8dB. The integrated IF filter has an additional production
tolerance of only ±7 kHz, hence, a frequency offset between the receiver and the transmitter of
±58 kHz can be accepted for XTAL and XTO tolerances.
Note:
This small sensitivity spread over supply voltage, frequency offset and temperature is very
unusual in such a receiver. It is achieved by an internal, very fast and automatic frequency cor-
rection in the FSK demodulator after the IF filter, which leads to a higher system margin. This
frequency correction tracks the input frequency very quickly; if, however, the input frequency
makes a larger step (for example, if the system changes between different communication part-
ners), the receiver has to be restarted. This can be done by switching back to IDLE mode and
then again to RX mode. For that purpose, an automatic mode is also available. This automatic
mode switches to IDLE mode and back into RX mode every time a bit error occurs.
Control Logic” on page
For the demodulator used in the ATA5423/ATA5425, the tolerable frequency offset does not
change with the data frequency, hence, the value of ±58 kHz is valid for up to 1
-110
-109
-108
-106
-105
-104
-103
-102
-101
-100
-107
-99
-98
-97
-96
-95
-100
Measured Sensitivity 433.92 MHz/FSK/20 Kbit/s/±16 kHz/Manchester versus
Frequency Offset, Temperature and Supply Voltage
-80
Figure 3-2 on page 13
-60
ATA5423/ATA5425/ATA5428/ATA5429
36.)
-40
Frequency Offset (kHz)
-20
0
the supply voltage has almost no influence. The tem-
20
40
60
80
100
V
V
V
V
V
V
V
V
V
S
S
S
S
S
S
S
S
S
= 2.4V T
= 3.0V T
= 3.6V T
= 2.4V T
= 3.0V T
= 3.6V T
= 2.4V T
= 3.0V T
= 3.6V T
Kbit/s
amb
amb
amb
amb
amb
amb
amb
amb
amb
= -40 C
= -40 C
= -40 C
= +25 C
= +25 C
= +25 C
= +105 C
= +105 C
= +105 C
(See “Digital
.
13