ADM00310 Microchip Technology, ADM00310 Datasheet - Page 9

• Manufacturer Part Number: ADM00310
• Description: BOARD EVAL FOR MCP3903 AFE
• Manufacturer: Microchip Technology
• Series: -r

Specifications of ADM00310

• Design Resources: MCP3903 Eval Brd BOM MCP3903 Eval Brd Schematic
• Main Purpose: Interface, Analog Front End (AFE)
• Embedded: Yes, MCU, 16-Bit
• Utilized Ic / Part: MCP3903, PIC24F, PIC24H, dsPIC33, MCP2200
• Primary Attributes: -
• Secondary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

2.0
The MCP2200 is configured by writing special
commands using the HID interface. Configuration can
be achieved using the configuration utility provided by
Microchip. Alternatively, a custom utility can be
developed by using the DLL available on the MCP2200
product page.
2.1
The configuration utility provided by Microchip allows
the user to configure the MCP2200 to custom defaults.
The configuration utility (shown in
to the device’s HID interface, where all of the
configurable features can be set.
2.2
The MCP2200 is supplied from the factory with a
serialized USB serial string.
TABLE 2-1:
 2011 Microchip Technology Inc.
Vendor ID (0x04D8)
Product ID (0x00DF)
Baud Rate
IO Config
IO Default
Tx/Rx LEDs
Hardware Flow Control
USBCFG Pin
Suspend Pin
Invert Sense
Manufacturer String
Product String
Configuration Name
CONFIGURATION
Configuration Utility
Serial String
CONFIGURATION DESCRIPTIONS
Figure
The USB vendor identification assigned to Microchip by the USB consortium.
Device ID assigned by Microchip. The device can be used “as-is”, or Microchip
can assign a custom PID by request.
Sets the UART baud rate using a list of primary baud rates. See the UART
section for details on setting non-primary baud rates.
Individually configures the I/O to inputs or outputs.
Individually configures the output default state for pins configured as outputs.
Enables/disables the GP6 and GP7 pins to function as USB traffic indicators.
Pins are active low when configured as traffic indicators.
Enables/disables CTS and RTS flow control.
Enables/disables the GP1 pin as a USB configuration status indicator.
Enables/disables the GP0 pin as a USB suspend status pin.
Enables/disables the UART lines states:
USB manufacturer string.
USB product string.
- Normal – Tx/Rx idle high; CTS/RTS active low
- Inverted – Tx/Rx idle low; CTS/RTS active high
2-1) connects
Description
MCP2200
DS22228B-page 9