STEVAL-PCC010V2 STMicroelectronics, STEVAL-PCC010V2 Datasheet - Page 8

• Manufacturer Part Number: STEVAL-PCC010V2
• Description: BOARD EVAL FOR ST802RT1A
• Manufacturer: STMicroelectronics
• Series: -r

Specifications of STEVAL-PCC010V2

• Design Resources: STEVAL-PCC010V2 BOM STEVAL-PCC010V2 Schematic
• Main Purpose: Interface, Ethernet Controller (PHY and MAC)
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: ST802RT1A, STM32F207
• Primary Attributes: 1 Port, 100BASE-TX/10BASE-T
• Secondary Attributes: MII, RMII
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-11465

Getting started
4
4.1
4.1.1
4.1.2
4.1.3
4.2
8/34
Getting started
This section briefly describes how to start using the STEVAL-PCC010V2, ST802RT1A
Ethernet PHY TX mode demonstration kit. In order to use this demonstration kit a web
browser must be installed on your PC.
Package contents
The ST802RT1A Ethernet PHY TX mode demonstration kit includes the following:
Hardware content
●
●
Software content
●
Documentation
●
●
How to run the demonstration software
This section describes the demonstration software delivered with the ST802RT1A Ethernet
PHY TX mode demonstration kit. The software implements a simple web server based on
lwIP TCP/IP stack. The web server consists of three pages displaying some general
information about STM32 and ST802RT1A, allowing to control LEDs on the STM32F207
controller demonstration board, and also shows the content of the ST802RT1A PHY
registers.
To run the demonstration software one STEVAL-PCC010V2 demonstration kit, an Ethernet
cable, and a PC with a web browser is required.
One ST802RT1A Ethernet PHY demonstration board
One STM32F207 controller demonstration board
Web server - demonstration software based on lwIP TCP/IP stack
STM32 and ST802RT1A datasheets
This user manual
Doc ID 18370 Rev 1
UM1041