TDA7294V STMicroelectronics, TDA7294V Datasheet - Page 9

• Manufacturer Part Number: TDA7294V
• Description: IC AMP AUDIO 100W AB MULTIWATT15
• Manufacturer: STMicroelectronics
• Type: Class ABr

Specifications of TDA7294V

• Output Type: 1-Channel (Mono)
• Max Output Power X Channels @ Load: 100W x 1 @ 8 Ohm
• Voltage - Supply: ±10 V ~ 40 V
• Features: Depop, Mute, Short-Circuit and Thermal Protection, Standby
• Mounting Type: Through Hole
• Package / Case: Multiwatt-15 (Vertical, Bent and Staggered Leads)
• Product: Class-AB
• Output Power: 100 W
• Available Set Gain: 80 dB
• Thd Plus Noise: 0.01 %
• Operating Supply Voltage: 50 V
• Supply Current: 65 mA
• Maximum Power Dissipation: 50000 mW
• Maximum Operating Temperature: + 70 C
• Mounting Style: Through Hole
• Audio Load Resistance: 8 Ohms
• Dual Supply Voltage: +/- 12 V, +/- 15 V, +/- 18 V, +/- 24 V, +/- 28 V
• Input Bias Current (max): 0.5 uA
• Input Offset Voltage: + 0.5 V to - 0.5 V
• Input Signal Type: Differential
• Minimum Operating Temperature: 0 C
• Output Signal Type: Single
• Supply Type: Dual
• Amplifier Class: AB
• No. Of Channels: 1
• Supply Voltage Range: ± 10V To ± 40V
• Load Impedance: 4ohm
• Operating Temperature Range: 0°C To +70°C
• Amplifier Case Style: Multiwatt15
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-2171-5

Figure 16: Turn ON/OFF Suggested Sequence
In addition to the overload protection described
above, the device features a thermal shutdown
circuit which initially puts the device into a muting
state (@ Tj = 145
Figure 17: Single Signal ST-BY/MUTE Control
MUTE/
ST-BY
Circuit
10K
o
C) and then into stand-by (@
V ST-BY
V MUTE
PIN #10
PIN #9
V OUT
(mV)
(mA)
+Vs
V IN
-Vs
20K
(V)
(V)
(V)
(V)
1N4148
I P
+35
-35
30K
ST-BY
MUTE
OFF
5V
5V
10 F
STBY
MUTE
D93AU014
10 F
PLAY
Tj = 150
Full protection against electrostatic discharges on
every pin is included.
3) Other Features
The device is provided with both stand-by and
mute functions, independently driven by two
CMOS logic compatible input pins.
The circuits dedicated to the switching on and off
of the amplifier have been carefully optimized to
avoid any kind of uncontrolled audible transient at
the output.
The sequence that we recommend during the
ON/OFF transients is shown by Figure 16.
The application of figure 17 shows the possibility
of using only one command for both st-by and
mute functions. On both the pins, the maximum
applicable range corresponds to the operating
supply voltage.
MUTE
o
C).
ST-BY
OFF
D93AU013
TDA7294
9/17