NAR131S Stanley Electric Co, NAR131S Datasheet - Page 2

• Manufacturer Part Number: NAR131S
• Manufacturer: Stanley Electric Co

Specifications of NAR131S

• Display Type: Segmented
• Configuration: Common Anode
• Emitting Color: Red
• Number Of Digits: 1
• Digit Size (in): .31in
• Viewing Area Height (mm): 8mm
• Viewing Area Length (mm): 4mm
• Package Type: DIP
• Operating Temperature Classification: Commercial
• Operating Temp Range: -30C to 85C
• Mounting: Through Hole
• Pin Count: 10
• Total Thickness (mm): 5mm
• Opto Display Type: Module
• Pattern Type: Segmented
• Lead Free Status / Rohs Status: Compliant

HANDLING PRECAUTIONS
*
Residual solder of flux left on the LED housing could reduce intensity
and could affect the optical characteristics. Excess flux can be
removed by the following chemical method:
DIP Soldering and cleaning is not recommended for Alpha-Numeric (AAR121and AAA121) LED displays.
1. Cleaning solvents (dipping time: 3 minutes maximum at
2. The effect of ultrasonic cleaning on the LED resin body depends
3. The solvent for freon equivalent (recommended after confirming
Soldering Conditions
Cleaning
normal temperature)
on such factors as the oscillator output, size of PCB and LED
mounting method. Ultrasonic cleaning is strongly recommended
after confirming that there are no problems.
that there are no problems).
• Ethyl alcohol
• Isopropyl alcohol
• Pure water (after cleaning, the water must be removed
• Drying condition: 90°C max., 30 sec. max. and 4 times max.
1. Ultrasonic wave frequency: 28 kHz or 40 kHz
2. Output: 20 W/I
• AK-225AES
• Clean through
• Pine alpha ST-100S
by drying)
TYPES
Isopropyl alcohol
Ethyl alcohol
Pure water
Chemicals
Temperature at tip of iron:
300°C max. (30 W max.)
Soldering time: 3 sec. max
Location: At least 3.0mm away from resin body
Freon substitute detergent
Clean through 705H
Pine alpha ST-100S
SOLDERING IRON
AK225AES
Pre-heating: 80°C max.
(Resin surface temperature)
60 sec. max
Bath temperature: 260°C max.
Dipping time: 5 sec. max.
Location: At least 3.0mm away from resin body
DIP SOLDERING
REFLOW SOLDERING
Not recommended
3