104652-1 TE Connectivity, 104652-1 Datasheet - Page 5

• Manufacturer Part Number: 104652-1
• Manufacturer: TE Connectivity

Specifications of 104652-1

• Connector Type: Connector Assembly
• Mount Angle: Vertical
• Pcb Mount Retention: With
• Mating Connector Lock: Without
• Hold-down Post Material: Copper Alloy
• Hold-down Post Plating: Tin-Lead (150) over Nickel (50)
• Insulation Resistance (m?): 5,000
• Voltage (vac): 30
• Dielectric Withstanding Voltage (v): 300
• Contact - Rated Current (a): 1 – 4
• Solder Tail Contact Plating: Tin-Lead (150)
• Number Of Positions: 10
• Pcb Mount Retention Type: Hold Down Post(s)
• Contact Base Material: Copper Alloy
• Contact Plating, Mating Area, Material: Gold (30)
• Underplate Material: Nickel
• Connector Style: Receptacle
• Mating Alignment: With
• Mating Alignment Type: Polarizing Tab
• Housing Material: Thermoplastic - GF
• Ul Flammability Rating: UL 94V-0
• Housing Color: Black
• Rohs/elv Compliance: ELV compliant, 5 of 6 Compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Approved Standards: UL E28476, CSA LR7189
• Temperature Range (°c): -65 – +105
• Packaging Method: Tube

|
4.
4.1.
4.2.
4.3.
4.4.
Rev C
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets requirements of Figure 1. Failures attributed
to equipment, test setup or operator deficiencies shall not disqualify the product. When product failure
occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to confirm
corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected from current production. Test groups shall consist of a minimum of 5 vertical receptacles
and shrouded headers containing at least 30 contacts total. Test group 1 shall consist of the
smallest and largest position sizes available. Test groups 2, 3 and 4 shall each consist of the
largest position size available.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figure 2.
Termination Resistance Measurement Points
Figure 3
108-1332
5 of 7