1-794407-1 TE Connectivity, 1-794407-1 Datasheet - Page 7

• Manufacturer Part Number: 1-794407-1
• Manufacturer: TE Connectivity

Specifications of 1-794407-1

• Product Type: Contact
• Connector Line: Mini-Universal MATE-N-LOK
• Wire Insulation Diameter (mm [in]): 2.01 – 3.20 [0.079 – 0.126]
• Voltage (vac): 600
• Termination Method: Crimp
• Solder Tail Contact Plating: Matte Tin over Nickel
• Wire Range (mm [awg]): 0.50-1.40² [20-16]
• Contact Type: Socket
• Contact Termination Type: Crimp
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold (30)
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not reviewed for lead free solder process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Wire/Cable
• Packaging Method: Strip

4.
4.1.
4.2.
4.3.
4.4.
Rev D
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to
confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. All test groups shall each consist of 5 random
connector assemblies. All contacts shall be crimped to appropriate test conductors per Application
Specification 114-16017.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figures 2 and 3.
NOTE
Bulk wire resistance shall be subtracted from resistance readings.
Dry Circuit Resistance Measurement Points
Figure 3
108-1542
7 of 10