STM8L101G3 STMicroelectronics, STM8L101G3 Datasheet - Page 62

• Manufacturer Part Number: STM8L101G3
• Description: Ultra Low Power MCUs, STM8L
• Manufacturer: STMicroelectronics

Specifications of STM8L101G3

• Low Power Consumption (halt: 0.3 μA, Active-halt
• Temp. Range: -40 to 85 °C and 125 °C
• Three Low Power Modes: Wait, Active-halt, Halt

Electrical parameters
9.3.9
62/81
EMC characteristics
Susceptibility tests are performed on a sample basis during product characterization.
Functional EMS (electromagnetic susceptibility)
Based on a simple running application on the product (toggling 2 LEDs through I/O ports),
the product is stressed by two electromagnetic events until a failure occurs (indicated by the
LEDs).
●
●
A device reset allows normal operations to be resumed. The test results are given in the
table below based on the EMS levels and classes defined in application note AN1709.
Designing hardened software to avoid noise problems
EMC characterization and optimization are performed at component level with a typical
application environment and simplified MCU software. It should be noted that good EMC
performance is highly dependent on the user application and the software in particular.
Therefore it is recommended that the user applies EMC software optimization and
prequalification tests in relation with the EMC level requested for his application.
Prequalification trials:
Most of the common failures (unexpected reset and program counter corruption) can be
reproduced by manually forcing a low state on the NRST pin or the oscillator pins for 1
second.
To complete these trials, ESD stress can be applied directly on the device, over the range of
specification values. When unexpected behavior is detected, the software can be hardened
to prevent unrecoverable errors occurring (see application note AN1015).
Table 34.
Symbol
V
V
FESD
EFTB
ESD: Electrostatic discharge (positive and negative) is applied on all pins of the device
until a functional disturbance occurs. This test conforms with the IEC 61000-4-2
standard.
FTB: A burst of fast transient voltage (positive and negative) is applied to V
through a 100 pF capacitor, until a functional disturbance occurs. This test conforms
with the IEC 61000-4-4 standard.
Voltage limits to be applied on any I/O pin to
induce a functional disturbance
Fast transient voltage burst limits to be
applied through 100 pF on V
pins to induce a functional disturbance
EMS data
Parameter
Doc ID 15275 Rev 11
DD
and V
SS
LQFP32, V
LQFP32, V
LQFP32, V
DD
DD
DD
Conditions
3.3 V
3.3 V, f
3.3 V, f
HSI
HSI
/2
STM8L101xx
DD
and V
Level/
Class
3B
3B
4A
SS