STR731FV0 STMicroelectronics, STR731FV0 Datasheet - Page 21

no-image

STR731FV0

Manufacturer Part Number
STR731FV0
Description
32-BIT ARM7 FLASH MICROCONTROLLER WITH 3x CAN, 4 UARTs, 20 TIMERS, ADC, 12 COMM. INTERFACES
Manufacturer
STMicroelectronics
Datasheet

Specifications of STR731FV0

5 Power Saving Modes
SLOW, WFI, LPWFI, STOP and HALT modes
6/10 16-bit Timers (tim) Each With
2 input captures, 2 output compares, PWM and pulse counter modes
Conversion Time
min. 3μs, range

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
STR731FV0T6
Manufacturer:
ON
Quantity:
34 000
Part Number:
STR731FV0T6
Manufacturer:
STMicroelectronics
Quantity:
10 000
Part Number:
STR731FV0T6
Manufacturer:
ST
0
Part Number:
STR731FV0T7
Manufacturer:
STMicroelectronics
Quantity:
10 000
Part Number:
STR731FV0T7
Manufacturer:
ST
0
STR73xFxx
4
4.1
4.1.1
4.1.2
4.1.3
4.1.4
4.1.5
Electrical parameters
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T
given only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean±2Σ)
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Pin input voltage
The input voltage measurement on a pin of the device is described in
Figure 6.
L
=50pF
Pin loading conditions
STR7 PIN
Figure 7.
A
=25° C and T
A
SS
=25° C and V
.
Pin input voltage
.
V
IN
A
Electrical parameters
=T
Figure
DD
Amax
=5 V. They are
STR7 PIN
Figure
7.
(given by the
6.
21/52

Related parts for STR731FV0