L6599 STMicroelectronics, L6599 Datasheet - Page 6

• Manufacturer Part Number: L6599
• Description: High-voltage resonant controller
• Manufacturer: STMicroelectronics

Specifications of L6599

• Dimensions (l/w/h): 132 mm / 52 mm / 22 mm
• Universal Ac Mains Range: 90 VAC to 264 VAC
• High Output Power: 90 W (4.74 A, 19 VDC)
• Very Low Output Noise And Ripple: less than 300 m VP-P
• Very Low Standby Power: less than 0.5 W at 264 V
• Hiccup Mode: Auto recovery with SCP
• Latch Mode: OVP acts while VOUT > 29 VDC

Typical system block diagram
Table 2.
3
6/36
N.
11
12
13
14
15
16
VBOOT
Name
Pin functions (continued)
OUT
HVG
N.C.
LVG
V
Typical system block diagram
Figure 3.
CC
Low-side gate-drive output. The driver is capable of 0.3 A min. source and 0.8 A min. sink
peak current to drive the lower MOSFET of the half-bridge leg. The pin is actively pulled to
GND during UVLO.
Supply Voltage of both the signal part of the IC and the low-side gate driver. Sometimes a
small bypass capacitor (0.1 µF typ.) to GND might be useful to get a clean bias voltage for
the signal part of the IC.
High-voltage spacer. The pin is not internally connected to isolate the high-voltage pin and
ease compliance with safety regulations (creepage distance) on the PCB.
High-side gate-drive floating ground. Current return for the high-side gate-drive current.
Layout carefully the connection of this pin to avoid too large spikes below ground.
High-side floating gate-drive output. The driver is capable of 0.3 A min. source and 0.8A min.
sink peak current to drive the upper MOSFET of the half-bridge leg. A resistor internally
connected to pin 14 (OUT) ensures that the pin is not floating during UVLO.
High-side gate-drive floating supply Voltage. The bootstrap capacitor connected between
this pin and pin 14 (OUT) is fed by an internal synchronous bootstrap diode driven in-phase
with the low-side gate-drive. This patented structure replaces the normally used external
diode.
Typical system block diagram
Function
L6599