STOD03A STMicroelectronics, STOD03A Datasheet - Page 12

• Manufacturer Part Number: STOD03A
• Description: Dual DC-DC converter for powering AMOLED display
• Manufacturer: STMicroelectronics

Specifications of STOD03A

• Typical Efficiency: 85%
• Low Quiescent Current: < 1 μA in shutdown mode
• Temperature Range: - 40 °C to 85 °C

Detailed description
6
6.1
6.1.1
6.1.2
6.1.3
12/23
Detailed description
S
●
●
1.
2.
3.
S
●
●
●
●
●
S
●
●
●
●
●
S
●
●
WIRE
WIRE
WIRE
WIRE
Protocol: to digitally communicate over a single cable with single-wire components
Single-wire’s 3 components:
An external MCU
Wiring and associated connectors
STOD13AS device with a dedicated single-wire pin.
Fully digital signal
No handshake needed
Protection against glitches and spikes though an internal low pass filter acting on falling
edges
Uses a single wire (plus analog ground) to accomplish both communication and power
control transmission
Simplify design with an interface protocol that supplies control and signaling over a
single-wire connection to set the output voltages.
Single-wire protocol uses conventional CMOS/TTL logic levels (maximum 0.6 V for
logic “zero” and a minimum 1.2 V for logic “one”) with operation specified over a supply
voltage range of 2.5 V to 4.5 V
Both master (MCU) and slave (STOD13AS) are configured to permit bit sequential data
to flow only in one direction at a time; master initiates and controls the device
Data is bit-sequential with a START bit and a STOP bit
Signal is transferred in real time
System clock is not required; each single-wire pulse is self-clocked by the oscillator
integrated in the master and is asserted valid within a frequency range of 250 kHz
(maximum).
The negative output voltage levels are selectable within a wide range (steps of 100 mV)
The device can be enabled / disabled via S
features and benefits
protocol
basic operations
Doc ID 17785 Rev 2
WIRE
in combination with the Enable pin.
STOD03A