MAX4329 Maxim, MAX4329 Datasheet - Page 11

• Manufacturer Part Number: MAX4329
• Description: The MAX4322/MAX4323/MAX4326/MAX4327/MAX4329 family of operational amplifiers combines wide bandwidth and excellent DC accuracy with rail-to-rail operation at the inputs and outputs
• Manufacturer: Maxim

Figures 9 and 10 show the output voltage and supply
current on power-up of the test circuit in Figure 8.
The MAX4323 and MAX4327 have a shutdown option.
When shutdown (SHDN) is pulled low, the supply cur-
rent drops to 25µA per amplifier and the amplifiers are
disabled with the outputs in a high-impedance state.
Pulling SHDN high or leaving it floating (1µA internal
pullup) enables the amplifier. In the dual-amplifier
MAX4327, the shutdown functions operate indepen-
dently. Figures 11 and 12 show the output voltage and
supply current responses of the MAX4323 to a shut-
down pulse.
The MAX4322/MAX4323/MAX4326/MAX4327/MAX4329
operate from a single 2.4V to 6.5V power supply, or
from dual supplies of ±1.2V to ±3.25V. For single-supply
operation, bypass the power supply with a 0.1µF
ceramic capacitor in parallel with at least 1µF. For dual
supplies, bypass each supply to ground.
Good layout improves performance by decreasing the
amount of stray capacitance at the op amp’s inputs and
outputs. To decrease stray capacitance, minimize trace
lengths and resistor leads by placing external compo-
nents close to the op amp.
Design the layout for the device to be as compact as
possible to minimize parasitics. The UCSP uses a
bump pitch of 0.5mm (19.7mil) and a bump diameter of
0.33mm (~12mil). Therefore, lay out the solder-pad
spacing on 0.5mm (19.7mil) centers, using a pad size
of 0.25mm (~10mil) and a solder mask opening of
Figure 7. Capacitive-Load-Driving Circuit
Single/Dual/Quad, Low-Cost, UCSP/SOT23,
______________________________________________________________________________________
Power Supplies and Layout
MAX4322/MAX4323
MAX4326/MAX4327
MAX4329
UCSP Information
Low-Power, Rail-to-Rail I/O Op Amps
R
S
Layout Issues
C
L
0.33mm (13mil). Round or square pads are permissi-
ble. Connect multiple vias from the ground plane as
close to the ground connections as possible.
Install capacitors as close as possible to the device
supply voltage input. Place the ground end of these
capacitors near the ground plane to provide a low-
impedance return path for the signal current.
Alignment keys on the PC board, around the area
where the chip is located, are helpful in the prototype
assembly process. It is better to align the chip on the
board before any other components are placed, and
then place the board on a hot plate or hot surface until
the solder starts melting. Remove the board from the
hot plate without disturbing the position of the chip and
let it cool down to room temperature before processing
the board further.
Figure 8. Power-Up Test Circuit
MAX4323EBT (UCSP) Marking Information
POWER-UP
STEP FOR
0 TO 2.7V
TEST
TOP VIEW
(BUMPS ON BOTTOM)
2k
V
2k
CC
Prototype Chip Installation
A1
10
AAA
AAA
A2
MONITORING POINT
SUPPLY-CURRENT
A3
MAX4322/MAX4323
MAX4326/MAX4327
ORIENTATION
PRODUCT ID CODE
LOT CODE
MAX4329
V
OUT
10k
11